Earticle

For observation training of firing weapons, military operates Joint Fire Training Simulator system. During the acceptance test for deployment of weapon system, it occurred that could increase training fatigue in mock observation device. This study describes in cause analysis and improvement activities to solve it. Due to the characteristics of observing training with a small image panel through the ocular, image noise and skipping are factors that cause fatigue to training. It was analyzed that the noise of image was caused by HDMI (High-Definition Multimedia Interface) splitter and design change was promoted. In addition, it was determined that the image skip occurred due to the software filter for stabilizing the image of mock observation device. It was solved by improving the calculation error of accumulating data. Securing the quality of observation images is expected to reduce training fatigue and contribute to improving the training environment.

The existing production and manufacturing process was manually operated and the cleaning process was not constant due to poor environmental conditions for several hours, so the production efficiency was significantly lowered and manufacturing cost was increased. In this R&D, productivity improved by doubling the production of 300 units per hour to 700 units, and in this development, manufacturing costs were lowered through this process improvement project based on automotive shoba automation technology.

Thin-film shape technology is recognized for its core technology to enhance the technology of LCD, PDP, semiconductor manufacturing processes, hard disks and optical disks, and is widely used to form coated thin films of products. In addition, resistance(electron beam filament) technology for heating is used to manufacture filament for ion implants used in semiconductor manufacturing processes. By establishing an electronic beam filament production system and developing seven specifications of electronic beam filament, it is contributing to improving trade dynamics and increasing exports to Japan through localized media of theoretical imports to domestic companies. In this study, CAE analysis was performed after setting electron beam filament specification and development objectives, facilities and fabrication for electron beam filament production, electron beam filament JIG & fixture design and fabrication followed by electron beam filament prototype. Then, the automation and complete inspection equipment of the previously developed electronic beam filament manufacturing facilities was developed and researched to mass-produce them, to analyze and modify prototypes, design and manufacture automation facilities, and finally, to design and manufacture the complete inspection equipment. In this paper, mainly electron beam filament specification analysis and development objectives and CAE analysis were dealted with.

The SLA 3d printer is the first of the commercial 3D printer. The 3D printed output is printed hanging on the bed that move to the upper position. Sandblasted bed is used to prevent layer shift. If sandblasting is wrong, the 3D printed output is layer shifted. For this reason, 3D printer manufacturing companies inspect the bed surface. However, the sandblasted surface has variety of irregular shapes and craters, so it is difficult to establish a quality control standard. To solve problems, this paper presents a standardized sandblasting histogram and threshold. We present a filter that can increase the classification rate.