잔여 수명 기반 교체 전략 강화 및 그룹별 균형 유지보수를 고려한 전력 설비 유지보수 최적화
Power Equipment Maintenance Optimization Considering Remaining Useful Life-Based Replacement Prioritization and Balanced Maintenance Across Groups
Optimizing maintenance for power equipment is a critical task for ensuring system reliability and sustaining long-term asset health under budget constraints. Conventional maintenance optimization is typically driven by cost efficiency, which favors low-cost actions such as general maintenance, potentially leading to the underselection of replacement strategies and the concentration of maintenance budgets on specific equipment groups. To address these limitations, after formulating a general maintenance optimization problem (P0), this study proposes a remaining useful life (RUL)-based replacement strategy reinforcement method (P1) and a group-balanced maintenance method (P2). Based on the expected remaining useful life estimated from a two-parameter Weibull distribution, P1 defines replacement-importance weights to increase the likelihood of selecting replacement for equipment that has reached the end of its useful life. P2 mitigates maintenance bias across groups using Lagrangian relaxation and the subgradient method. Experimental results under various numbers of equipment units and groups show that, whereas conventional maintenance optimization never selected replacement under any condition, the proposed P1 and P2 selected replacement for equipment that had reached the end of its useful life.In addition, compared with P1, P2 reduced the coefficient of variation of group-wise budgets increasingly with problem size (up to 31.1% for 1,000 units), significantly alleviating both inter-group budget imbalance and inequality in maintenance allocation. Furthermore, compared with a cost-efficiency greedy rule and a remaininguseful- life threshold replacement rule, the proposed methods attained both budget-constrained optimality and group equity, whereas the simple rules severely degraded reliability and equity. Finally, the runtimes of P0 and P1 were under 1 second, and even P2, which requires iterative convergence, completed within about 10 seconds on a commodity laptop, confirming the practical applicability of all proposed methods to maintenance planning problems.
한국어
전력 설비 유지보수 최적화는 예산이 제한된 상황에서 시스템 신뢰도를 확보하고 장기적 자산 건전성을 유지하기 위한 핵심 과제이다. 기존의 유지보수 최적화는 비용 효율을 중심으로 수행 되어 일반보수와 같은 저비용 전략을 선호하여 교체 전략을 과소 선택할 수 있으며, 특정 설비 그룹에 유지보수 예산이 편중되는 한계가 있다. 본 연구는 이러한 한계를 완화하기 위해 범용적인 유지보수 최적화 문제(P0)를 정식화한 후, 잔여 수명 기반 교체 전략 강화 기법(P1)과 그룹별 균형 유지보수 기법(P2)을 제안한다. P1은 2-모수 Weibull 분포로부터 계산한 기대 잔여 수명을 바탕으로 교체 중요도 가중치를 정의하여, 수명이 다한 설비의 교체 선택 가능성을 높인다. P2는 그룹 간 유지보수 편향을 완화하는 기법이며, 이를 구현하기 위해 라그랑주 완화 및 부분경사법을 사용한다. 다양한 설비 수 및 그룹수 조건에서 실험을 수행한 결과, 전통적인 유지보수 최적화 기법은 모든 조건에서 교체 전략을 선택하지 않았으나, 제안하는 P1 및 P2는 수명이 다한 설비를 교체하는 전략을 선택하였다. 또한, P2는 P1 대비 그룹별 예산 변동계수를 문제 규모가 커질수록 더 크게 감소시켜(설비 수 1,000 기준, 최대 31.1% 감소) 그룹별 예산 불균형과 설비간 유지보수 불평등을 상당수준 완화했다. 아울러 제안 기법을 비용효율 그리디 및 잔여 수명 임계 기반 교체 규칙과 비교하여, 단순 규칙이 신뢰도와 형평성을 크게 훼손하는 것과 달리 제안 기법은 예산 제약 조건에서 최적성과 그룹 형평성을 동시에 확보함을 확인하였다. 마지막으로, P0 및 P1의 실행 시간은 1초 미만이며 반복 수렴이 필요한 P2의 경우에도 일반 사양의 노트북에서 약 10초 이내로 측정되어, 제안하는 모든 기법이 유지보수 계획 수립 문제에 실용적으로 적용될 수 있음을 확인하였다.
목차
요약 Abstract 1. 개요 1.1 연구 배경 1.2 기존 연구와 한계 1.3 본 연구의 접근방법(제안하는 기법) 1.4 연구 기여 1.5 논문 구성 2. 관련 연구 2.1 전력 설비와 유지보수의 중요성 관련 연구 2.2 유지보수 최적화 및 예측 유지보수 관련 연구 2.3 기존 연구의 한계와 본 연구의 차별성 3. 제안하는 전력 설비 유지보수 최적화 기법 3.1 문제 정의 3.2 유지보수 최적화 문제 P0 3.3 제안하는 기법 P1: 잔여 수명 기반 교체 전략강화 3.4 제안하는 기법 P2: 그룹별 균형 유지보수 4. 실험 및 성능 분석 4.1 실험 환경 및 설정 4.2 교체 전략 선택 비율 및 신뢰도 상충 관계 분석 4.3 그룹별 균형 유지보수 효과 분석 4.4 베이스라인 대비 성능 비교 4.5 p2의 수렴 특성 분석 4.6 모수 민감도 및 데이터 일반화 4.7 단기 신뢰도와 장기 위험의 상충 관계 4.8 공개 실데이터 기반 사례연구 4.9 실행 시간 및 실용성 분석 5. 결론 및 향후 연구 계획 Acknowledgements 참고문헌