As the structural design method has been changed from the elastic strength design method to the ultimate strength design method, the number of shear reinforcing bars increased greatly. In this paper, we propose a method of arranging a large number of legs into two. With this method, we analyze the Workability & Economic Efficiency, economic feasibility, and inner force of the main bars and concluded as follows. First, 3 ~ 6 legs of shear reinforcement may show no problem in the drawing, but when the upper bar concentrated at the end of the beam is complex, the 90° & 135° hook must anchor the upper and lower reinforcement bars. This method needs to be improved because various expedient have occurred due to poor constructability and poor workability for hanging a 90 ° hook on the upper bar by hooking the lower bar upward. Second, by reorganizing the existing number of shear reinforcing bars into two and arranging them, and therefore by drastically reducing the total installation work, the amount of rebar can be reduced by up to 26%. Third, by developing a simplified detail and using D10 / 2 section on the lower bar, an increase in the bending strength of the girder was found to occur 10~24%.
목차
Abstract 1. 서론 2. 전단보강근 설계와 설치방법 2.1 전단보강근의 변화 2.2 전단보강근 구조제한 사항 2.3 내진설계시 고려사항 2.4 철근공사비 책정 2.5 전단보강근의 설계 및 설치현황 3. 개량안 도출 3.1 개량안 도출 목표 3.2 개선된 전단보강근의 표준화 4. 현장적용성 검토 4.1 구조 엔지니어링 지원 4.2 철근 기능공 교육 4.3 적용에 따른 전단철근 절감효과 4.4 기타 5. 결론 REFERENCES
대한건축학회지회연합회 [The Regional Association of Architectural Institute of Korea]
설립연도
2000
분야
공학>건축공학
소개
본회는 건축에 관한 학술․ 예술․ 기술을 연구 연마하는 지회회원들의 입지향상과 회원상호간의 친목도모와 함께 건축 문화창달에 기여함을 목적으로 한다.
목적을 달성하기 위하여 다음의 사업을 한다.
1. 지회회원의 입지향상과 친목도모
2. 건축에 관한 조사․연구지도 및 이에 관련된 사업
3. 회지, 논문집, 연구보고서 기타 건축에 관한 도서의 간행
4. 건축에 관한 강습회․강연회․간담회․전람회․견학회 등의 개최
5. 건축에 관한 계획, 감독, 기술검토에 대한 국가공공기관 기타의뢰에 관한 사항
6. 국내외 관계 제 학회와의 교류 및 회의참석
7. 기타 본회 목적달성에 필요한 사업
간행물
간행물명
대한건축학회연합논문집 [Journal of the Regional Association of Architectural Institute of Korea]