Earticle

초록

영어

The proposed design method minimizes bias, i.e., an average time to signal for the shift of process from the target value (ATS) curve, as well as it applies a VSI method to an attribute control chart for detecting a process shift efficiently. First, the results of the factorial experiment obtained by various parameter circumstances show that the VSI control chart using nearly unbiased ATS design provides the smallest decreasing rate in ATS among other charts for all experimental cases. Second, we illustrate that the control limits on the VSI control vhart using Shewhart method cannot satisfy false alarms when control parameters are small. This problem causes process over-control, unnecessary costs increase, and changeful factor. While, about all parameter values, a nearly unbiased ATS design satisfies restrictions for given false alarm. Third, we represent that a process change is rapidly detected when short sampling interval  approximate to min . In addition, the change of the sampling interval may not influence in a set of control chart parameters. Fourth, we demonstrate ATS curve has large bias establishing the parameter of VSI control chart using the Shewhart method. However, the proposed design method for the development of a control chart robust of sample size and control parameter size. Finally, We present an optimization model that may efficiently provide optimal ATS values for process parameters in a steady state, and that may efficiently establish parameters of correct control chart by supplying an optimization algorithm.

목차

Ⅰ. 서론
 Ⅱ. VSI 계수치 관리도의 근사 비편향 ATS 설계
 Ⅲ. 수치실험 및 비편향성 평가
 Ⅳ. 수행도 평가
 Ⅴ. 결론
 참고문헌
 Abstract

키워드

저자

• 배홍석 [ Hong-Seok Bae | 동아대학교 산업공학과 ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  생산성연구: 국제융합학술지 [Productivity Research: An International Interdisciplinary Journal]

• 간기

  격월간

• pISSN

  1225-3553

• 수록기간

  1987~2025

• 등재여부

  KCI 등재

• 십진분류

  KDC 325 DDC 330