This paper presents a finite element model-based real-time simulation system for the permanent magnet synchronous motor (PMSM) driving system, which, in combination with the vehicle kinetic model, forms a complete electric vehicle (EV) hardware-in-the-loop (HIL) simulation and test platform. The software JMAG is used to establish the PMSM finite element model, and the platform of field-programmable gate array (FPGA) is adopted to construct the PMSM real-time simulation model. The finite element model is also retrieved to coordinate with the vehicle kinetic model in order to facilitate the testing and development of the controller of the EV, the matching of the driving system, the kinetics control algorithms, etc. Through comparing the real-time simulation of the motor driving system with the experimental results of the test bench, as well as analyzing the HIL simulation results of the entire vehicle model, this paper verifies the accuracy and effectiveness of this HIL simulation and test platform.
목차
Abstract 1. Introduction 2. The Overall Structure of Evs’ HIL Test Platform 3. Building the HIL System Model 3.1. The Mathematical Model of the Three-Phase Inverter 3.2. The PMSM Motor Model 3.3. The JMAG-Based PMSM Model 3.4. The Kinematic Model of the Vehicle 4. Data Acquisition and Interaction of the HIL System 5. Experimental Verification and Results Analysis 5.1. Comparison between the HIL and the Bench Test Results 5.2. Results and Analysis of the Vehicle HIL Test Based on the Driving System Model of the Motor 6. Conclusion References
키워드
EVPMSM drive systemHILFEA
저자
Song Chuanxue [ State Key Laboratory of Automotive Simulation and Control, Jilin University, China ]
Xiao Feng [ State Key Laboratory of Automotive Simulation and Control, Jilin University, China ]
Peng Silun [ State Key Laboratory of Automotive Simulation and Control, Jilin University, China ]
보안공학연구지원센터(IJMUE) [Science & Engineering Research Support Center, Republic of Korea(IJMUE)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Multimedia and Ubiquitous Engineering
간기
월간
pISSN
1975-0080
수록기간
2008~2016
등재여부
SCOPUS
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Multimedia and Ubiquitous Engineering Vol.11 No.1