Earticle

초록

영어

This paper proposes the optimal structure of a Printed Circuit Board-based micro-PCR Chip constructed on a PCB substrate using commercial adhesive tapes and plastic films. The proposed micro-PCR chip was composed of four layers. In a previous experiment, the chip had been made with a green PCB, yielding an unwanted reflection that prevented accurate analysis. In this study, the solder mask of the PCB substrate was coated black for a higher signal-to-noise ratio, and the area where the reaction chamber was attached was legend-printed with white silk for better reflection of the fluorescence light. The top cover, which was 180𝜇m thick, was also colored black to minimize the noise during fluorescence detection. As a result of carrying out PCR, it was found that the fluorescence brightness increased with increasing numbers of cycles.

목차

Abstract
 1. Introduction
 2. Black PCB-Based Micro-PCR Chip
  2.1. PCR Chip Driving System
  2.2. The Proposed PCR Chip Structure
 3. Experiments and Results
 4. Conclusion
 Acknowledgments
 References

키워드

저자

• Ji-Soo Hwang [ Dept. of Computer Engineering, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Jong-Dae Kim [ Dept. of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Yu-Seop Kim [ Dept. of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Hye-Jeong Song [ Dept. of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Chan-Young Park [ Dept. of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Control and Automation

• 간기

  월간

• pISSN

  2005-4297

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605