In this paper a low-power pulse-triggered structure and a modified true single latch structure based on a signal feed-through scheme is designed in TSMC CMOS 180 nm technology. The Pulse triggered flip-flop (P-FF) solves the problem of long discharging path and achieves better speed and power performance. The pre and post lay-out simulations has been done using Cadence tool, the performance analysis on power-delay-product metrics are obtained through simulation and finally a 4-bit RAM is designed by using P-FF and then the implementation has been done on SOC 11.10 technology.
목차
Abstract 1. Introduction 2. P-FF Design based on Signal Feed through Scheme 3. Design of 4 Bit Static-RAM using P-FF 4. Implementation of 4 Bit Static-RAM using P-FF on SoC (System on Chip) 5. Simulation Results 6. Conclusion References
키워드
S-RAMSignal feed-throughSoC Technology
저자
G. Suresh [ Assistant Professor, Department of ECE, GMR Institute of Technology, RAJAM. ]
N. V. Lalitha [ Assistant Professor, Department of ECE, GMR Institute of Technology, RAJAM. ]
R. Aamani [ PG Student, Department of ECE, GMR Institute of Technology, RAJAM. A.P, INDIA ]
보안공학연구지원센터(IJUNESST) [Science & Engineering Research Support Center, Republic of Korea(IJUNESST)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of u- and e- Service, Science and Technology
간기
격월간
pISSN
2005-4246
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of u- and e- Service, Science and Technology Vol.8 No.9