Earticle

초록

영어

A biochip can obtain various types of genetic information over a short period of time and enable genetic analysis. A biochip needs temperature sensors to measure temperature. A resistance temperature detector temperature sensor chip, made of copper using a printed circuit board, was introduced in this study. A printed circuit board is readily usable for copper pattern design for the substrate of a biochip. To measure biochip resistance, we tested whether it was possible to accurately measure the temperature using resistances measured at room temperature and at 55, 72, 85, and 95°C in a water bath. However, in analyzing the results obtained, the printed circuit board based resistance temperature detector sensor was found to be inadequate for use as a biochip temperature sensor, although it showed potential for use as a general-purpose resistance temperature detector sensor.

목차

Abstract
 1. Introduction
 2. Methods
 3. Results
 4. Conclusions
 Acknowledgments
 References

키워드

저자

• Sang-Yoon Kim [ Department of Computer Engineering, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Jong-Dae Kim [ Department of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Yu-Seop Kim [ Department of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Hye-Jeong Song [ Department of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]
• Chan-Young Park [ Department of Convergence Software, Hallym University, Bio-IT Research Center, Hallym University, Korea ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Control and Automation

• 간기

  월간

• pISSN

  2005-4297

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605