Heat-carrier heating device is an important part of biomass pyrolysis oil equipment. In particular, the application of vertical heat-carrier heating device can improve the rate of biomass pyrolysis. In this article, we will analyze the vertical carrier heating device based on FLUENT software and model the temperature field and velocity field of hot gas and carrier so as to draw a conclusion that the final temperature of carrier can reach approximately 840K which can meet the biomass pyrolysis process temperature. Meanwhile, the movement of carrier is very smooth without any stoppage thus laying a solid foundation for the improvement and optimization of the device.
목차
Abstract 1. The Structure and Working Principles of Vertical Carrier Heating Device 1.1 The Structure of Vertical Carrier Heating Device 1.2 The Working Principles of Vertical Carrier Heating Device 2. The Model Establishment of Vertical Carrier Heating Device 2.1 The Parameters of the Main Structure and the Building of Three-Dimensional Model 2.2 Mathematical Description 2.3 The Model Grid Division and Boundary Conditions 3. Simulation Results and Analysis 3.1. The Selection of the Relaxation Factor 4. Conclusion Acknowledgements Reference:
키워드
Heat-Carrier Heating DeviceVerticalFLUENT
저자
Liu Xin [ Northeast Forestry University, Harbin 150040, P.R. China ]
Wangshuyang [ Northeast Forestry University, Harbin 150040, P.R. China ]
Sunbingxiao [ Northeast Forestry University, Harbin 150040, P.R. China ]
Xueguolei [ Northeast Forestry University, Harbin 150040, P.R. China ]
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.8 No.8