Earticle

초록

영어

In order to achieve convenient and rapid detection of pulse signal, a real-time detection system of photoelectric pulse signal based on Bluetooth transmission is proposed in this paper. The system mainly includes pulse sensor, Arduino processor board, Bluetooth modules and PC management platform. The pulse signal collected by pulse senor will be sent to Arduino processor board after being filtered and amplified. Then Arduino processor board will conduct A/D conversion and data processing on pulse signal. Thus pulse rate and time between heartbeats can be calculated, transmitted and displayed in real-time on PC management platform which is written by Processing Language. The results of the system test show that the pulse signal detection system implemented above can be served as practical application reliably.

목차

Abstract
 1. Introduction
 2. Design of Pulse Signal Detection System
 3. Hardware Design of the System
  3.1 Hardware Design of Pulse Sensor
  3.2 Hardware Design of Arduino Board
  3.3 Hardware Design of Bluetooth Module
 4. Software Design of the System
  4.1 Software Design of Arduino Board
  4.2 Software Design of Bluetooth Module
  4.3 Software Design of PC Management Platform
 5. System Test and Extension
 6. Conclusions
 Acknowledgements
 References

키워드

저자

• Qingchao Gong [ School of Mechanical, Electrical and Information Engineering, Shandong University, Weihai, 264209, China ]
• Guangming Li [ School of Mechanical, Electrical and Information Engineering, Shandong University, Weihai, 264209, China ]
• Peng Sun [ School of Mechanical, Electrical and Information Engineering, Shandong University, Weihai, 264209, China ]
• Yong Pang [ School of Mechanical, Electrical and Information Engineering, Shandong University, Weihai, 264209, China ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Control and Automation

• 간기

  월간

• pISSN

  2005-4297

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605