This paper addresses Low Noise Amplifier design which is also known as LNA for any application in wireless communication system. LNA is a very important part in RF receiver because when using a LNA noise can reduced by the gain by the amplifier when the noise of the amplifier is received directly from received signal. The low noise amplifier have designed to get the better performance by follow the requirement in this new era consists of high gain, low noise figure, lower power consumption, small chip area, low cost and good input and output matching. It is also used for excellent input and output matching and has a potential to get a lower noise. While for active inductor, is used to obtain the lower power consumption and to reduce the chip size in layout design.
목차
Abstract 1. Introduction 2. Methodology 3. Background Studies 4. The Proposed LNA 5. Results and Discussion 6. Conclusions References
키워드
active inductorCGLNAsmall area
저자
A. Hameed [ Faculty of Manufacturing Engineering, Universiti Malaysia Pahang ]
Ali Oudah [ Faculty of Manufacturing Engineering, Universiti Malaysia Pahang ]
보안공학연구지원센터(IJMUE) [Science & Engineering Research Support Center, Republic of Korea(IJMUE)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Multimedia and Ubiquitous Engineering
간기
월간
pISSN
1975-0080
수록기간
2008~2016
등재여부
SCOPUS
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Multimedia and Ubiquitous Engineering Vol.10 No.1