This paper presents a high-efficiency AC-DC switch-mode power supply (SMPS) using the full-bridge converter circuits. The proposed converter utilizes three full-bridge converter circuits: two full-bridge diode converter circuits and one full-bridge MOSFET converter circuit. The two full-bridge converters are utilized at the primary AC input and the secondary DC output, respectively, and the full-bridge MOSFET converter is used to convert a DC voltage to a high-frequency AC voltage that is converted to another DC voltage with the transformer and the secondary full-bridge diode converter, which is simply referred to as the full-bridge DC-DC converter. However the conventional full-bridge converter has a limit in its operating duty ratio in normal operation, because it results in more conduction loss in light load operation. Therefore, the proposed converter resolves the drawbacks of the conventional full-bridge converter using a modified full-bridge circuit with a DC blocking capacitor in the primary. Thus, the proposed converter has improved total efficiency and performance. The operation principle of the proposed converter is described in detail, and a design example of a prototype is shown. The good performance of the proposed converter is demonstrated through experimental results of the implemented prototype based on the design example.
목차
Abstract 1. Introduction 2. The Proposed SMPS 3. The Mode Analysis of the Proposed Converter 4. Design Example 5. Experimental Results 6. Conclusion Acknowledgements References
키워드
AC-DC switch-mode power supplyFull-bridge diode/MOSFET converter
저자
Su-Han Kwon [ Department of Electronic Information Engineering, Soonchunhyang University 22 Soonchunhyang-Ro, Shinchang-Myun, Asan-Si, Choongnam, South Korea ]
Doo-Hee Yoo [ Department of Electronic Information Engineering, Soonchunhyang University 22 Soonchunhyang-Ro, Shinchang-Myun, Asan-Si, Choongnam, South Korea ]
Gang-Youl Jeong [ Department of Electronic Information Engineering, Soonchunhyang University 22 Soonchunhyang-Ro, Shinchang-Myun, Asan-Si, Choongnam, South Korea ]
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.7 No.6