In view of the problem of difficult to suppress surplus torque and to obtain high servo accuracy at high frequency in the passive torque servo system(PTSS), the neural network PID control strategy with surplus torque compensation based on dynamic fuzzy neural network (DFNN) and double-stator motor is proposed. Firstly the model of the PTSS is built and the mathematical model of surplus torque is derived. Then the model of surplus torque is identified by DFNN. The surplus torque is estimated in real time and converted directly to the control signals of outer stator of double-stator motor which produces torque to compensate the surplus torque. Finally the parameters of the neural network PID (NNPID) controller are adjusted in real time according to the Jacobian information and system error. The Jacobian information is obtained from the online identification of PTSS by RBF neural network. The simulation results show that surplus torque model is close to the actual surplus torque system, that compensation control largely eliminates the surplus torque, that system performance is improved and that the control strategy is successful.
목차
Abstract 1. Introduction 2. PTSS Structure 3. Surplus Torque Model Identification Based on DFNN 4. System Control Strategy 5. Simulation Results 5.1. Model validation 5.2. Surplus torque suppression 5.3. System Torque tracking response 6. Conclusion Acknowledgements References
키워드
DFNNdouble-stator motorNNPIDsurplus torquePTSS
저자
Zhisheng Ni [ School of Electrical Engineering and automation Harbin Institute of Technology ]
Mingyan Wang [ School of Electrical Engineering and automation Harbin Institute of Technology ]
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.7 No.6