In the wireless body sensor network system (WB-SNS), saving energy in sensor nodes is a high priority. As an energy-saving method for sensor nodes, the transmission power control (TPC) algorithm has been developed. The TPC technique is a method of saving energy by adjusting the transmission power of the radio chip inside a sensor node. Numerous TPC algorithms exist, but in this paper, the dynamic TPC algorithm was analyzed intensively. The existing dynamic TPC algorithm utilizes a linear equation to find the optimal transmission power level (TPL). However, the existing dynamic TPC algorithm may operate well when the channel condition is good but it could estimate the TPL inaccurately due to the generation of an incorrect linear equation when the channel conditions are bad. Therefore, to solve the problem described above, this paper proposes an extended dynamic TPC algorithm that can estimate errors earlier based on slope values, which can be extracted at the time of generation of the linear equation, and estimate transmission power better by reutilizing the existing transmission power to create a more accurate equation. Through an experiment, this paper also proves that the extended dynamic TPC algorithm showed better performance compared to the existing dynamic TPC algorithm.
목차
Abstract 1. Introduction 2. Related Work 3. Extended Dynamic Transmission Power Control 4. Comparison of Dynamic and Extended Dynamic Transmission Power Control 5. System Architecture and Experimental Setup 6. Experimental Result 7. Conclusion Acknowledgements References
키워드
body sensor network systemsdynamic transmission power controlclosed loop systemwearable sensorswireless sensor network
저자
Woosik Lee [ Dept. of Computer Science, Kyonggi Univ. Korea ]
Min Choi [ School of Info. and Comm. Eng., Chungbuk National Univ., Korea ]
Namgi Kim [ Dept. of Computer Science, Kyonggi Univ. Korea ]
Corresponding author
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.6 No.6