Earticle

초록

영어

Purpose: This study evaluated the influence of build orientation on the dimensional accuracy of three-dimensional (3D)-printed implant surgical guides. Methods: Implant surgical guides for the maxillary premolar region were designed using computer-aided design software, and identical stereolithography files were printed at three build angles (0°, 45°, and 90°) with 10 samples per group. Following postcuring, all specimens were scanned with a dental 3D scanner, and their fit was assessed by superimposing the scanned data onto the original design using 3D analysis software. Root mean square (RMS) deviation was calculated, and one-way ANOVA and Tukey’s HSD post hoc test were performed for statistical analysis (α=0.05). Results: RMS values showed significant differences among groups (p<0.001). The 45° group exhibited the lowest mean RMS value, indicating the highest accuracy, whereas the 90° group had the largest deviation. Conclusion: Build orientation significantly affected the dimensional accuracy of 3D-printed implant surgical guides. A 45° orientation produced the most accurate results and may provide a practical guideline for optimizing clinical precision and standardizing printing conditions.

목차

Abstract
INTRODUCTION
MATERIALS AND METHODS
1. 임플란트 수술 가이드 설계 및 STL 파일 추출
2. 3D 프린팅 시편 제작
3. 시편 스캔 및 데이터 분석
4. 통계분석
RESULTS
DISCUSSION
CONCLUSIONS
FUNDING
ACKNOWLEDGEMENTS
CONFLICT OF INTEREST
REFERENCES

키워드

저자

• 배은정 [ Eun-Jeong Bae | 부천대학교 치기공과 ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  대한치과기공학회지 [THE JOURNAL OF KOREAN ACADEMY OF DENTAL TECHNOLOGY]

• 간기

  계간

• pISSN

  1229-3954

• eISSN

  2288-5218

• 수록기간

  1979~2026

• 등재여부

  KCI 등재

• 십진분류

  KDC 515 DDC 617