Gye-Nam Kim, Sung-Yeol Lee, Hui-Jun Won, Chong-Hun Jung, Won Zin Oh
언어
한국어(KOR)
URL
https://www.earticle.net/Article/A45461
※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.
원문정보
초록
영어
The size and main ingredient of hot particulate generated during the nuclide experiment in hot cells of nuclear facilities were 0.5300 m and UO. A cyclone filter equipment which consists of a cyclone and Bag/HEPA filter was devised to remove hot particulate generated during the nuclide experiment in hot cells of nuclear facilities. The experimental conditions to maximize the collection efficiency of hot particulate were suggested through experiments done with the cyclone filter equipment. With the large size of simulated particulate, the collection efficiency of the particulate was high. When the size of simulated particulate was more than 5 m, the collection efficiency of the particulate was more than and when the size of simulated particulate was less than 1.0 urn, the collection efficiency decreased by less than . If the inflow velocity of simulated particulate was increased, the collection efficiency of the particulate was also increased. When the inflow velocity of simulated particulate was more than 12m/sec, the collection efficiency was higher than , but after 17 m/sec inflow velocity, no change observed. The collection efficiency of the simulated particulate can be enhanced with the length of vortex finder inside the chamber. With the length of vortex finder, 7.2cm, the observed collection efficiency of the particulate was the maximum. Moreover, when the sub-cone was attached under the cyclone, the collection efficiency of cyclone increased . It was found that effect by attachment of sub-cone was not serious.
한국어
원자력시설 핫셀 (Hot Cell)내에서 핵종실험 시 발생하는 고방사능 분진(Hot Particulate)의 크기는 0.5300 이고 주 핵종은 UO였다. 핫셀 내의 고방사능 분진을 제거하기 위해 사이클론과 Bag/HEPA필터로 구성된 장치를 고안하였고, 이 장치의 사이클론에 의해 고방사능 분진을 최대로 포집할 수 있는 실험조건을 제시했다. 모의입자의 크기가 클수록 입자의 포집효율은 높았다. 모의 입자의 크기가 5 이상일 때, 입자의 포집효율은 보다 높았다. 모의 입자의 크기가 1.0 보다 작을 때, 포집효율은 보다 작았다. 모의 입자의 유입속도가 12 m/sec보다 클 때, 포집효율은 보다 높았다. 그러나 유입속도가 17 m/sec 보다 클 때 포집효율의 증가율은 크지 않았다. 모의입자의 포집효율은 Vortex Finder의 길이가 7.2 cm이하일 때, 길이의 증가와 함께 높아졌지만 7.2 cm 이상일 때는 낮아지기 시작했다. 그러므로 Vortex Finder의 길이가 7.2 cm 일 때, 최대포집효율을 나타냈다. 사이클론 밑에 보조콘 부착 시 모든 속도 범위에서 약 평균 정도 포집효율이 증가하므로 보조콘 부착효과가 크지 않았다.
목차
ABSTRACT 요약 I. 서론 II. 고방사능 분진 오염특성 분석 및 사이클론 제작실험 가. 고방사능 분진의 오염특성 분석 나. 사이클론 제작 III. 미립자 제거효율실험 가. 크기에 따른 미립자 제거효율 도출 실험 나. 미립자 최적 유입속도 결정 실험 다. 최적 Vortex Finder 길이 결정 실험 라. 사이클론에 보조콘 부착 후 실험 III. 결과 및 토의 가. 포집 가능 최적 미립자크기 도출 실험 나. 미립자 최적 유입속도 결정 실험 다. 최적 Vortex Finder 길이 결정 실험 라. 사이클론에 보조콘 부착 후 실험 IV. 결론 사사 References
한국방사성폐기물학회는 국내 방사성폐기물 관리 분야 산ㆍ학ㆍ연 관계자들의 학술단체로 학술연구발표회 및 강연회 개최, 학술간행물 발간 등의 학술 진흥사업, 방사성폐기물에 관한 국제교류 및 협력 증진사업, 방사성폐기물에 관한 위탁연구 자문 및 평가사업 수행 등으로 국내 방사성폐기물 관리 분야 전반의 내부 역량 강화와 경쟁력 확보를 도모하고자 한다. 더 나아가 국가사회 발전에 미치는 중요성을 인식하는 계기를 만들고자 한다. 또한 이러한 활동을 통하여 국가경제 발전과 국민건강에 일조할 수 있도록 하며, 궁극적으로는 한국방사성폐기물학회가 세계 속의 학술단체로의 발전해 나가는 것을 목표로 한다.
간행물
간행물명
방사성폐기물학회지 [Journal of Nuclear Fuel Cycle and Waste Technology (JNFCWT)]