Effects of Variation in the Amount of Coagulant Injection on the Treatment Characteristics of Fiber ball Media Filter
응집제 주입량 변화가 섬유볼 여과장치 처리특성에 미치는 영향
Junho Lee, ByungChan Lee, Ikjun Youn, ByungWook Kang, Jeongdong Choi, Myeongho Kim
언어
한국어(KOR)
URL
https://www.earticle.net/Article/A444775
※ 기관로그인 시 무료 이용이 가능합니다.
4,000원
원문정보
초록
영어
Non-point source pollution such as rainfall runoff water are mostly composed of fine particles of 100 μm or less, so pollutants are easily adsorbed and attached to move. Studies on a filtration method using a coagulant are also being conducted to treat these fine particles with high efficiency, but the method using a coagulant has its efficiency depending on the amount of coagulant injected, so it is essential to inject an optimal coagulant according to the treatment conditions. Therefore, in this paper, a coagulant was injected into the upflow filtration column device to which the fiber ball filter was applied to improve the processing efficiency of fine particles, and the injection amount of the coagulant in the device was different to calculate the optimal amount of the coagulant injection and analyze the processing characteristics of the filtration device according to the change in the injection amount. As a result of the experiment, when the concentration of the coagulant injection to the influent water was 15.625 mg/L, the highest fine particle treatment efficiency was found with a turbidity average of 98.88% and an SS average of 98.76%, and above that, the treatment efficiency slightly decreased. In addition, as a result of calculating the backwashing efficiency through the calculation of the solid mass balance, the backwashing efficiency decreased as the amount of the coagulant injection increased, indicating that the injection of the coagulant had a direct effect on the backwashing. Therefore, when the high efficiency treatment is performed by injecting a coagulant into the upflow fiber ball filtration device, it is considered to be the most efficient and appropriate agglomerate filtration condition when the concentration of the coagulant injection is 15.625 mg/L.
한국어
강우유출수와 같은 비점오염원은 대부분 100 m 이하의 미세입자로 이루어져 있어 오염물질들이 흡착 및 부착되어 거동 하기 쉬운 특성을 가지고 있다. 이러한 미세입자를 고효율로 처리하기 위해 응집제를 이용한 여과방식에 대한 연구도 진행되 고 있으나 응집제를 이용한 방식은 응집제 주입량에 따라 그 효율이 달라져 처리 조건에 따른 최적의 응집제 주입이 필수적 이다. 때문에 본 논문에서는 섬유볼 여재를 적용한 상향류식 여과 컬럼 장치에 응집제를 주입하여 미세입자 처리효율을 향상 시키고 장치 내 응집제 주입량을 달리하여 최적의 응집제 주입량 산정 및 주입량 변화에 따른 여과장치 처리특성을 분석하고 자 하였다. 실험 결과 유입수에 대한 응집제 주입 농도가 15.625 mg/L 일 때, 탁도 평균 98.88%, SS 평균 98.76%로 가장 높 은 미세입자 처리효율로 나타났으며 그 이상부터는 처리효율이 미세하게 감소하는 것으로 나타났다. 또한 고형물 물질수지 계산을 통해 역세척 효율을 산정한 결과, 응집제 주입량이 증가할수록 역세척 효율이 감소하여 응집제의 주입이 역세척에 직 접적인 영향을 끼치는 것으로 나타났다. 따라서 상향류식 섬유볼 여과장치에 응집제를 주입하여 고효율 처리를 진행할 경우, 응집제 주입농도를 15.625 mg/L로 할 때가 가장 고효율적이며 적절한 응집 여과 조건인 것으로 사료된다.
목차
Abstract 요약문 I. 서론 II. 연구방법 1. 실험실 규모 여과장치 시스템 설계 2. 실험실 규모 여과장치 시스템 제작 및 여재 3. 실험 및 분석 방법 III. 결과 및 고찰 1. 미세입자 처리효율 분석 2. 상관관계 분석 3. 응집제 주입량에 따른 역세척 효율 IV. 결론 사사 References
한국도시환경학회 [The Korean Society of Urban Environment]
설립연도
2001
분야
공학>환경공학
소개
산업화와 도시 집중화 및 교통의 증가에 따른 각종 공해 물질의 증가에 의하여 우리들이 살고 있는 도시환경은 오염되고 있을 뿐만 아니라 도시 생태계가 파괴되어 가고 있다. 이에 따라 우리들의 생산활동이나 공공교통 그리고 일상생활에서 발생하는 대기오염, 수질오염, 토양오염, 폐기물, 소음 및 진동 그리고 그 밖의 오염원으로부터 발생되는 오염물질 등은 인간의 건강 및 생명에 유해하며 나쁜 영향을 미칠 수 있으므로 이를 방지하기 위한 시급한 대처가 요구된다.
이러한 시대적 요청에 따라 본 한국도시환경학회는 도시환경과 관련된 모든 문제를 조사연구함으로써 도시환경학문의 발전과 응용 및 보급에 기여하고 나아가 사회 발전에 이바지함을 목적으로 설립되었다.
간행물
간행물명
한국도시환경학회지 [Journal of the Korean Society of Urban Environment]