Earticle

초록

영어

In order to investigate the optimum condition of the autofrettage process for the diesel engine fuel injection pipe, different values of autofrettage pressure, pressure rising time, pressure holding time, and repetition of autofrettage process were applied. Autofrettage was performed by applying the hydrostatic internal pressures of 604MPa, 535MPa, 500MPa on the fuel injection pipe, corresponding to theoretical 50%, 30%, and 20% overstrain levels, respectively. The autofrettage residual stresses in the injection pipe were experimentally determined by using X-ray diffractometer. As the overstrain level increased, the magnitude of compressive residual stress at the bore increased. It was found that the rising time to reach the autofrettage pressure, holding time at the autofrettage pressure, and repeated application of the autofrettage pressure on the pipe had no significant influence on the residual stress distributions.

목차

ABSTRACT
1. 서론
2. 자긴압력 및 잔류응력분포
3. 자긴가공 잔류응력 측정
4. 결론
References

키워드

저자

• 고승기 [ Seung-Kee Koh | Member, School of Mechanical Engineering, Kunsan National University ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  한국기계항공기술학회지(구 한국기계기술학회지) [Journal of the Korean Society of Mechanical and Aviation Technology ]

• 간기

  격월간

• pISSN

  1229-604X

• eISSN

  2508-3805

• 수록기간

  1999~2026

• 등재여부

  KCI 등재

• 십진분류

  KDC 550 DDC 620