Earticle

현재 위치 Home

Numerical analysis on the critical current evaluation and the correction of no-insulation HTS coil

첫 페이지 보기
  • 발행기관
    한국초전도저온학회 (구 한국초전도저온공학회) 바로가기
  • 간행물
    한국초전도·저온논문지 (구 한국초전도저온공학회논문지) KCI 등재 SCOPUS 바로가기
  • 통권
    Vol.25 No.1 (2023.03)바로가기
  • 페이지
    pp.16-20
  • 저자
    Bonghyun Cho, Jiho Lee
  • 언어
    한국어(KOR)
  • URL
    https://www.earticle.net/Article/A430851

※ 기관로그인 시 무료 이용이 가능합니다.
※ 학술발표대회집, 워크숍 자료집 중 4페이지 이내 논문은 '요약'만 제공되는 경우가 있으니, 구매 전에 간행물명, 페이지 수 확인 부탁 드립니다.

4,000원

원문정보

초록

영어
The International Electrotechnical Commission (IEC) 61788-26:2020 provides guidelines for measuring the critical current of Rare-earth barium copper oxide (REBCO) tapes using two methods: linear ramp and step-hold methods. The critical current measurement criterion, 1 or 0.1 μV/cm of electric field from IEC 61788-26 has been normally applied to REBCO coils or magnets. No-insulation (NI) winding technique has many advantages in aspects of electrical and thermal stability and mechanical integrity. However, the leak current from the NI REBCO coil can cause distortion in critical current measurement due to the characteristic resistance which causes the radial current flow paths. In this paper, we simulated the NI REBCO coil by applying both linear ramp and step-hold methods based on a simplified equivalent circuit model. Using the circuit analysis, we analyzed and evaluated both methods. By using the equivalent circuit model, we can evaluate the critical current of the NI REBCO coil, resulting in an estimation error within 0.1%. We also evaluate the accuracy of critical current measurement using both the linear ramp and step-hold methods. The accuracy of the linear ramp method is influenced by the inductive voltage, whereas the accuracy of the step-hold method depends on the duration of the hold-time. An adequate hold time, typically 5 to 10 times the time constant (τ), makes the step-hold method more accurate than the linear ramp method.

목차

Abstract
1. 서론
2. REBCO 초전도 선재 및 코일의 임계전류 측정
2.1. Rare-earth barium copper oxide (REBCO) 초전도 선재의직류 임계전류 기준 : IEC 61788-26:2020 [3]
2.2. 절연 고온초전도 코일과 무절연 고온초전도 코일의회로해석 [4]
3. 고온초전도 코일 분석
3.1. 절연 고온초전도 코일 분석
3.2. 무절연 고온초전도 코일 분석
3.3. 회로해석을 사용한 보정방안
4. 결론
ACKNOWLEDGMENT
REFERENCES

저자

  • Bonghyun Cho [ Department of Electrical Engineering, Pusan National University, Busan, Korea ]
  • Jiho Lee [ Department of Electrical Engineering, Pusan National University, Busan, Korea, Robotics Institute of Non-Destructive Inspection, Pusan National University, Busan, Korea ] Corresponding Author

참고문헌

자료제공 : 네이버학술정보

간행물 정보

발행기관

  • 발행기관명
    한국초전도저온학회 (구 한국초전도저온공학회) [The Korean Society of Superconductivity and Cryogenics (KSSC)]
  • 설립연도
    1998
  • 분야
    공학>전기공학
  • 소개
    21세기 핵심기술인 초전도공학과 저온공학분야의 기술 수준을 향상시키고, 선진 외국의 관련 학회와의 국제 교류 뿐만 아니라 이 분야에서 산.학.연의 학술활동 및 기술교류의 구심점으로의 그 역할을 성실히 수행하고자 한다.

간행물

  • 간행물명
    한국초전도·저온논문지 (구 한국초전도저온공학회논문지) [Progress in Superconductivity and Cryogenics]
  • 간기
    계간
  • pISSN
    1229-3008
  • eISSN
    2287-6251
  • 수록기간
    1999~2026
  • 등재여부
    KCI 등재,SCOPUS
  • 십진분류
    KDC 427 DDC 537

이 권호 내 다른 논문 / 한국초전도·저온논문지 (구 한국초전도저온공학회논문지) Vol.25 No.1

    피인용수 : 0(자료제공 : 네이버학술정보)

    함께 이용한 논문 이 논문을 다운로드한 분들이 이용한 다른 논문입니다.

      페이지 저장