Earticle

현재 위치 Home

Waste Plastic Bottles for Concrete Brick Reinforcement as Building Material

첫 페이지 보기
  • 발행기관
    국제과학영재학회 바로가기
  • 간행물
    APEC Youth Scientist Journal 바로가기
  • 통권
    Vol. 10 No.1 (2020.09)바로가기
  • 페이지
    pp.1-9
  • 저자
    Kevyn Marie C. Gamutan, Francesca Louise A. Tupaz, Amanda Gaye A. Urag
  • 언어
    영어(ENG)
  • URL
    https://www.earticle.net/Article/A425038

※ 기관로그인 시 무료 이용이 가능합니다.

4,000원

원문정보

초록

영어
Urbanization with advanced technology has led to an increase of waste being generated leading to a waste disposal crisis. In order to reduce the accumulation of waste materials, this study aims to reuse plastic bottles to substitute a percentage of the primary materials used for concrete bricks. The feasibility of waste plastic bottles as cement additive in concrete was investigated. Plastic is a suitable study subject because it is sufficiently strong, can be used for load bearing structural materials and possesses excellent corrosion, moisture, and chemical resistance. Waste plastic bottles were collected, washed, air-dried for 24 hours, and cut into squares that measured no more than 1 cm. Rectangular concrete blocks were casted using 1:3:6:0.5 mass mix ratio of cement, sand, gravel, and water. A 0%, 10%, and 20% additive level of cement and waste plastic bottles was done in three replicates. Mechanical compressive strength was tested after 21 days of curing. Data shows that the compressive strength of concrete after 21 days of curing was 0.00306 MPa (control), 0.00303 MPa (with 10% waste plastic bottles), and 0.00103 MPa (with 20% waste plastic bottles). Results show that adding 10% waste plastic bottles to the cement mixture has similar compressive strength to that of the control group, while adding 20% waste plastic bottles to the cement mixtures shows a lower compressive strength than that of the control group. Results therefore suggest that using waste plastic bottles reinforces the mechanical compressive strength of the concrete brick.

목차

ABSTRACT
1. INTRODUCTION
1.1 Background of the Study
1.2 Statement of the Problem
1.3 Significance of the Study
1.4 Scope and Limitations
1.5 Definition of Terms
2. REVIEW OF RELATED LITERATURE
3. MATERIALS AND METHODS
3.1. Waste Plastic Bottle Collection and Preparation
3.2. Concrete Block Fabrication
3.3. Compressive Strength Test
4. RESULTS AND DISCUSSION
5. SUMMARY, CONCLUSION, AND RECOMMENDATIONS
5.1. Summary
5.2. Conclusion
5.3. Recommendations
ACKNOWLEDGMENTS
REFERENCES

저자

  • Kevyn Marie C. Gamutan [ A Science Investigatory Project Presented to the Faculty and Staff of Philippine Science High School Caraga Region Campus ]
  • Francesca Louise A. Tupaz [ A Science Investigatory Project Presented to the Faculty and Staff of Philippine Science High School Caraga Region Campus ]
  • Amanda Gaye A. Urag [ A Science Investigatory Project Presented to the Faculty and Staff of Philippine Science High School Caraga Region Campus ]

참고문헌

자료제공 : 네이버학술정보

간행물 정보

발행기관

  • 발행기관명
    국제과학영재학회 [The Society for the International Gifted in Science]
  • 설립연도
    2006
  • 분야
    자연과학>자연과학일반
  • 소개
    과학영재를 위한 연구 활동을 통하여 과학영재를 발굴하고, 발굴된 과학영재가 과학 분야의 관련 연구 활동을 할 수 있도록 지원하여, 이들이 과학 관련 분야의 진로를 선택하도록 장려함으로써 국제경쟁력을 갖춘 우수 과학기술인을 배출하고 국가 경제발전 및 문화창달과 세계 과학 발전에 기여함을 목적으로 한다.

간행물

  • 간행물명
    APEC Youth Scientist Journal [APEC 청소년 과학학술지]
  • 간기
    반년간
  • pISSN
    2005-5625
  • 수록기간
    2009~2022
  • 십진분류
    KDC 405 DDC 505

이 권호 내 다른 논문 / APEC Youth Scientist Journal Vol. 10 No.1

    피인용수 : 0(자료제공 : 네이버학술정보)

    함께 이용한 논문 이 논문을 다운로드한 분들이 이용한 다른 논문입니다.

      페이지 저장