Earticle

초록

영어

It has been suggested that the main battery voltage of electric vehicles (EVs) is increased from 400 to 800 V to improve the charging speed and driving distance. However, the secondary components in the dc/dc converter of the on-board charger (OBC) have high voltage stresses due to the increased battery voltage. Therefore, this paper proposes a double-voltage charging technique. The previously designed and optimized dc/dc converter for 400 V battery is used to charge 800 V battery. The battery stack is divided into two modules. Dc/dc converter charges one of two modules alternatively using the battery selection circuit (BSC). Since the BSC has low voltage stresses, the proposed converter can have low voltage stresses on all the dc/dc and BSC parts. Moreover, the dc/dc converter and BSC can be decoupled by turning off the dc/dc converter while changing the charged battery. Therefore, the loss of BSC can be minimized by operating it with low frequency because the switching frequency of BSC can be independent of that of the dc/dc converter. The design process can also be simpler owing to decoupling operation. The LLC converter was adopted for dc/dc converter with 3.3 kW output to verify the proposed technique.

목차

Abstract
I. INTRODUCTION
II. OPERATIONAL PRINCIPLE AND ANALYSIS
A. Motivation and Main Idea
B. Operatonal Principle
C. Design Considerations of Switching Frequency of QA1 and QA2
III. EXPERIMENTAL RESULTS
IV. CONCLUSION
REFERENCES

키워드

저자

• Ji-Yeon Kim [ Electrical Engineering Inha University Incheon, Korea ]
• Yeon-Ho Jeong [ Electrical Engineering University of Rhode Island RI, USA ]
• Jae-Kuk Kim [ Electrical Engineering Inha University Incheon, Korea ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  한국차세대컴퓨팅학회 학술대회

• 간기

  반년간

• 수록기간

  2021~2025

• 십진분류

  KDC 566 DDC 004