Earticle

초록

영어

By classifying temporary denture production for surgical guides, digital guide-based surgery, and final prosthesis production, the problems of each process were assessed in advance and the factors that could be improved were confirmed in this study. The manufacturing process of fusion dental prosthesis uses virtual programs and computed tomography images to manufacture devices using the latest technologies of computer-aided design/computer- aided manufacturing and three-dimensional printing, which enables implants to be placed in the desired location in advance. Moreover, implant placement is not dependent on the skill and condition of the dentist, and because it uses a computer system, it can always be performed at a constant and optimal position. This can reduce the remanufacturing rate compared with the general method, shorten the treatment period, and eliminate patient discomfort. Unlike the traditional method of using impression materials and plaster models, digital fusion dental prostheses would be evaluated as a technology for producing prosthesis through professional design technology and communication.

목차

Abstract
INTRODUCTION
CASE REPORT
1. 임시의치 제작
2. 방사선 가이드 제작
3. 3D planning과 디지털 가이드 제작
4. 주모형 제작
5. 상ㆍ하악 모형 부착
6. 납의치 제작
7. 상ㆍ하악 금속구조물 제작
8. 상ㆍ하악 보철물 완성
DISCUSSION
CONFLICT OF INTEREST
ORCID
REFERENCES

키워드

저자

• 김욱태 [ Wook Tae Kim | 신한대학교 바이오-생태 보건대학 치기공학과 ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  대한치과기공학회지 [THE JOURNAL OF KOREAN ACADEMY OF DENTAL TECHNOLOGY]

• 간기

  계간

• pISSN

  1229-3954

• eISSN

  2288-5218

• 수록기간

  1979~2026

• 등재여부

  KCI 등재

• 십진분류

  KDC 515 DDC 617