Earticle

초록

영어

Prior to the experimental and production stages of the center pillar, a structural analysis must be carried out at the design stage. The commercial software for the structural analysis at the design stage provides benefits such as cost-effective and time economy. In this study, the structural analysis was performed to investigate the stress and displacement characteristics of the center pillar for five types of the applied loads using SolidWorks. The equivalent stress was relatively larger on the outside plate than the inside plate. The maximum equivalent stress according to the change of the applied loads increased linearly in the range of 47~181%. The deformation was larger at the upper end of the center pillar, and the maximum displacement was linearly increased in the range of 35~187%. The analysis results of the center pillar according to the applied loads show that the location and distribution of the maximum stress and displacement of the center pillar can be predicted.

목차

ABSTRACT
 1. 서론
 2. 구조 및 형상 모델링
  2.1 센터필러 구조
  2.2 형상 모델링
 3. 전산해석 결과
 4. 결론
 References

키워드

저자

• 왕쩐후안 [ Zhen Huan Wang | Dep. of Mech. Eng., Sunmoon University, Graduated student ]
• 권영철 [ Young-Chul Kwon | Member, Dep. of Mech. Eng., Sunmoon University, Professor ] Corresponding author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  한국기계항공기술학회지(구 한국기계기술학회지) [Journal of the Korean Society of Mechanical and Aviation Technology ]

• 간기

  격월간

• pISSN

  1229-604X

• eISSN

  2508-3805

• 수록기간

  1999~2026

• 등재여부

  KCI 등재

• 십진분류

  KDC 550 DDC 620