Earticle

초록

영어

Among various materials, FCD500 is widely used in various fields of automobile components as it allows mass production through casting and its mechanical property is excellent. However, there are many problems in industry due to the fact that despite the wide use of FCD500, the researches about manufacture property of FCD500 are insufficient. Thus, this study conducted research on cutting manufacture property of FCD500, which is the most common manufacture method of FCD500 to suggest optimized tool and cutting condition. To achieve this, the study examined the change in cutting property based on tool material based on the most commonly used CVD(Chemical Vapor Deposition) coating tool and CBN tool, and examined the changes in cutting property by the form of CVD coating tool. The study measured cutting force, surface roughness of material after cutting, and amount of tool wear to examine the cutting property. The study gave variation in cutting speed of 280m/min and 500m/min, and fixed the feed rate and cutting depth for cutting condition to evaluate the changes by cutting speed.

목차

ABSTRACT
 1. Introduction
 2. Experiment devices and methods
  2.1 Test apparatus, test pieces
  2.2 Test method and cutting condition
 3. Experimental results and consideration
  3.1 Comparison of cutting force
  3.2 Comparative analysis on amount of tool wear
  3.3 Surface roughness evaluation
 4. Conclusion
 References

키워드

저자

• Jeong-hwan Lee [ 이정환 | Chon-buk National University ]
• Seung-hyeon Yoo [ 유승현 | Chon-buk National University ]
• Sung-hoon Oh [ 오성훈 | Member, Chon-buk National University ] Corresponding author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  한국기계항공기술학회지(구 한국기계기술학회지) [Journal of the Korean Society of Mechanical and Aviation Technology ]

• 간기

  격월간

• pISSN

  1229-604X

• eISSN

  2508-3805

• 수록기간

  1999~2026

• 등재여부

  KCI 등재

• 십진분류

  KDC 550 DDC 620