This paper deals with the preparation and characterization of Nickel-coated Alumina ceramic particles by Electroless Plating Technique. Nanosized α-Al2O3 powders of about 50nm in diameter are used for plating. The bath for Electroless Nickel Plating is prepared with NiCl2.6H2O, C6H5NaO7.H2O, NH4Cl and NaH2PO2.H2O. A bath temperature of 85°C, pH value of 8 and stirring time of 20 min is considered to carry out the deposition. The influence of sensitization and activation under different rinsing conditions on the Nickel coating over the Surface of Nano Alumina is studied. The results of these powders are analyzed through morphology, microstructure and phase with scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray diffractometry (XRD) respectively.
목차
Abstract 1. Introduction 2. Experimental 2.1. Raw Materials 2.2. Mechanism of Plating 2.3. Experimental Procedure 2.4. Characterization of Powders 3. Results and Discussion 4. Conclusions References
보안공학연구지원센터(IJAST) [Science & Engineering Research Support Center, Republic of Korea(IJAST)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Advanced Science and Technology
간기
월간
pISSN
2005-4238
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Advanced Science and Technology Vol.97