This paper proposes a new method for measuring the wind speed in the pipe, which overcomes the shortcomings of the traditional mechanical instrument with lower accuracy and ultrasonic measurement method with the high cost, it has the advantages of low cost and high precision. This paper introduces the principle of pendulum method to measure wind speed, the wind speed in the pipe is calculated by the space angle based on the spatial geometric relationship. On the other hand, the space angle is obtained by horizontal angle and vertical angle, which are gathered by the cameras placed in the ends of the bracket. Image processing technology is an important part of this method, including the image gray processing, binarization processing, edge detection and Hough transform steps, at last, the experimental results proved the feasibility of this method.
목차
Abstract 1. Introduction 2. Measuring Principles 2.1. Measurement Principle of Wind Speed 2.2. Measurement Principle of Space Angle θ 2.3. Measurement Principle of Flow 3. System Hardware Design 4. Image Processing Techniques 4.1. Grey Level Transformation 4.2. Binaryzation 4.3. Edge Detection 4.4. Hough Transform 4. Experiment and Analysis 4.1. Experimental Setup 4.2. Measure the Flow Field Distribution along the Center Line of the Tube 4.3. Measure the Flow Field Distribution along The Cross Section Of The Tube 5. Conclusion Acknowledgments References
보안공학연구지원센터(IJHIT) [Science & Engineering Research Support Center, Republic of Korea(IJHIT)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Hybrid Information Technology
간기
격월간
pISSN
1738-9968
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Hybrid Information Technology Vol.9 No.8