This Project deals with an fully parallel Embedded Z-source inverter(FPEZ) to control the three phase induction motor. Z-Source inverter is a single-stage converter which performs both buck-boost energy conversions using the LC impedance network. The further advancement in the Z-Source inverter is the partially parallel Embedded Z-Source(PPEZS) inverter that can produce same gain as Z-Source inverter but with lower capacitor voltage and ripples . In order to overcome the drawbacks of PPEZS, Fully parallel EZ-(FPEZS) Source inverter is proposed. The proposed inverters provide a high boost voltage inversion ability, a lower voltage stress across the active switching devices and capacitors with a continuous input current. In addition, they can suppress the startup inrush current, which otherwise might destroy the devices. The proposed system reduces six switch three phase inverter to four switch three phase inverter. This makes system compact which reduces cost and switching losses, line harmonics, improves power factor, reliability and extends the output voltage range. The system is modeled using Proteus and Simulink simulation. This paper presents the operating principles, analysis, and simulation results of FPEZ Source inverter.
목차
Abstract I. Introduction 1.1 Voltage Source Inverter (VSI) 1.2 Current Source Inverter (CSI) II. Impedance Source 2.1. Impedance Source Network 2.2. Equivalent Circuit &Modes Of Operation: III. Embedded Z Source Inverter 3.2. Fully Parallel EZ Source (FPEZ) IV. Implementation OF FPEZ FED Induction Motor 4.1. System Overview 4.2. Control Circuit V. Design OF FPEZ with Reduced Switches FED IM Motor VI. Simulation of Hardware Results VII. Conclusion References
키워드
Boost inversion abilityBuck-boostEmbedded Z sourceMotor drivesPEZSPWMvoltage boostZ Source Inverter
저자
V. Vidhya [ P.G Scholar Sriram Engineering College, Perumalpattu ]
L.Parimala [ Assistant Professor Sriram Engineering College, Perumalpattu ]
보안공학연구지원센터(IJGDC) [Science & Engineering Research Support Center, Republic of Korea(IJGDC)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Grid and Distributed Computing
간기
격월간
pISSN
2005-4262
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Grid and Distributed Computing Vol.9 No.6