Earticle

초록

영어

The structural vibration generated by building mounted small wind turbine was fully investigated by author. In order to achieve this, the real vibration condition of wind turbine in field was accurately simulated in Lab for research. There are some difficulty during the whole simulation process for further quantification of vibration levels. One of the main concerns was the correct estimation of the excitation or contact force at the interface between vibration source (turbine) and receiver (building or walls). However, the relevant simulation method in Lab is not available so far. In this paper, the direct measurement of force was investigated and found unsuitable. A new simulation method was proposed including solving the problem of power supply (DC electric motor used), automatic control of rotational speed of motor and indirect interface force determination. At last, the new established finite element models (FEM) was validated by experimental data with a good initial agreement.

목차

Abstract
 1. Introduction
 2. Theoretical Modal Analysis
 3. Experimental Modal Analysis (Impact Testing)
 4. Natural Frequencies’ Updating
  4.1. Material Properties (1st Updating)
  4.2. Pier-like Substructure (2nd Update)
  4.3. Elastically Supported Built-in End (3rd Update)
  4.4. Fine Tuning
 5. Commentary on the Results
 6. Harmonic Analysis
  6.1. Force Identification (A New Indirect/Inverse Force Estimation Method)
 7. Vibration Level Measurement – A Novel Lab Simulation Method
 8. Vibration Response Updating (Resonant Frequency)
  8.1 Frequency Range Set (1st Update)
  8.2.Solution Techniques (2nd Update)
  8.3. Summary
 9. Concluding Comments
 References

키워드

저자

• Bo Ren [ Structural Engineering, Faculty of Engineering, Sheffield University, Sheffield, UK ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Signal Processing, Image Processing and Pattern Recognition

• 간기

  격월간

• pISSN

  2005-4254

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605