Earticle

초록

영어

In advanced communication technology the microstrip filter has an important job in terms of selectivity and elimination of the undesired signals. In microwave and RF frequency applications the design of filter is complex task as lumped components cannot be used in this range of frequency. Microstrip filters are always preferred over the lumped filters at larger frequency for their compact size, lighter weight, lower cost and higher performance. In this paper the design of grooved microstrip patch resonator band-pass filter is presented at mid-band frequency 1.8 GHz for L-Band applications. It also acts as a band-reject filter at center frequency 1.1 GHz, which is innovative concept in microstrip filter design. Band-pass filter has a high attenuation in stop band, small insertion loss of 0.5744 dB and high return loss of 26.52 dB in the pass band whereas Band-reject filter has a low attenuation, high insertion loss of 21.95 dB and low return loss of 0.2432 dB in the stop band. The result is encouraging and fabrication is also very easy.

목차

Abstract
 1. Introduction
 2. Related Work
 3. Proposed Grooved Microstrip Filter
 4. Results and Filter Performance
 5. Conclusion
 References

키워드

저자

• Vivek Singh Kushwah [ Electronics and Communication Engineering Department Amity University, Gwalior, INDIA ]
• Geetam Singh Tomar [ Electronics and Communication Engineering Department MIR Labs, Gwalior, India and THDC IHET Tehri ]
• Sarita Singh Bhadauria [ Electronics and Communication Engineering Department Madhav Institute of Technology & Science, Gwalior, India ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Future Generation Communication and Networking

• 간기

  격월간

• pISSN

  2233-7857

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605