Earticle

초록

영어

In view of the problem that the joint type multiple DOF Manipulator is easy to collide with the surrounding equipment and jitter caused by the joint movement, this paper based on the stamping manipulator of five DOF cylindrical coordinate type, planned a straight path through actual stamping process in Cartesian space and quadratic programmed by using a bounded deviation theory. Then, this paper respectively used cubic polynomial, five polynomial and B-spline interpolation on interpolation points in joint space, and analyzed the displacement, velocity and acceleration of the end reference point. Finally, model in virtual prototype and real experiments were verified to ensure the safety and precision of the path. The results meet the requirements of the stamping process, succeeded in raising the stamping accuracy, and ensured the quality of stamping, and can arrange the entire auto production line equipment. So, it has important theoretical and practical significance to improve the stamping process.

목차

Abstract
 1. Introduction
 2. Research on the Linear Trajectory Planning of Stamping Manipulator
  2.1. Cartesian Space Trajectory Planning
  2.2. The Secondary Linear Trajectory Planning of Bounded Deviation Method
  2.3. Trajectory Planning in Joint Space
 3. Simulation of Virtual Prototype Model
  3.1. Cartesian Space Trajectory Simulation
  3.2. Difference Calculation Trajectory Simulation
  3.3. Joint Space Trajectory Simulation
 4. Stamping Manipulator Experimental Platform
 5. Results and Analysis
  5.1. Cartesian Spatial Displacement Simulation
  5.2. End Displacement Simulation after the Difference
  5.3. Physical Simulation of the Joint Spatial Reference Points
 6. Conclusions
 Acknowledgements
 References

키워드

저자

• Su Chunjian [ College of Mechanical and Electronic Engineering, Shandong University of Science and Technology. 266590 Qingdao. China. ]
• Yan Nannan [ College of Mechanical and Electronic Engineering, Shandong University of Science and Technology. 266590 Qingdao. China. ]
• Lou Shumei [ College of Mechanical and Electronic Engineering, Shandong University of Science and Technology. 266590 Qingdao. China. ]
• Zhang Xiaodong [ College of Mechanical and Electronic Engineering, Shandong University of Science and Technology. 266590 Qingdao. China. ]
• Lu Shun [ College of Mechanical and Electronic Engineering, Shandong University of Science and Technology. 266590 Qingdao. China. ]
• Wang Qing [ College of Civil Engineering and Architecture, Shandong University of Science and Technology, 266590 Qingdao. China ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Signal Processing, Image Processing and Pattern Recognition

• 간기

  격월간

• pISSN

  2005-4254

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605