Earticle

초록

영어

This paper focuses on a temperature effects on a PV panel which has been installed in Thailand. The main objective is cleaning PV panels and reduce temperature of PV panel by water injects from waterway and experimental results of PV power what it is difference. This project is designed by PLC control system which water injects and control PV temperature, In addition, this project consists of hardware and software such as water pump, water injection and PLC control has been automatically and it can be control system manually. The automatic control system is working when PV temperature rises up over 45 degree Celsius after that the pumping machine would inject water to the surface of PV panels and it must be stop when the PV panel temperature comes down less than 45 degree Celsius. The result of actual experimental found that the control system has been done correctly under specify condition. The experimental has been shown electrical data before and after water injects on PV system found that the electrical power a bit increases and The energy has been taken from PV panel less than energy consumption equipment of control system which taken to operate the water injecting system.

목차

Abstract
 1. INTRODUCTION
 2. TEMPERATURE EFFECT ON PV PANELS AND PV MODEL
  2.1 USEFULL EQUATIONS FOR DECISION INTERM OF TEMPERATURE
 3. EXPERIMENTAL SETUP
  3.1 CONTROL SYSTEM AND EXPERIMENTAL SETUP
  3.2 EXPERIMENTAL RESULTS
 4. CONCLUSION
 REFERENCES

키워드

저자

• Ong-art Sadmai [ Department of Electrical Engineering, Faculty of Engineering, Rajamangala University of Technology Thanyaburi. Prathumthani, Thailand ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  The International Journal of Advanced Smart Convergence

• 간기

  계간

• pISSN

  2288-2847

• eISSN

  2288-2855

• 수록기간

  2012~2025

• 십진분류

  KDC 326 DDC 380