Earticle

현재 위치 Home

Design Active Intelligent Multi Degrees of Freedom Joint Controller for Dental Automation

첫 페이지 보기
  • 발행기관
    보안공학연구지원센터(IJHIT) 바로가기
  • 간행물
    International Journal of Hybrid Information Technology 바로가기
  • 통권
    Vol.8 No.10 (2015.10)바로가기
  • 페이지
    pp.41-62
  • 저자
    Maryam Rahmani, Nasim Sobhani, Hamid Cheraghi Farzin Piltan, Farzin Matin
  • 언어
    영어(ENG)
  • URL
    https://www.earticle.net/Article/A257217

※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.

원문정보

초록

영어
Following the developments in industrial robot technology, robotics has found its way into the medical field and is used in a range of surgical disciplines. The main purpose of the use of robots is to increase the precision, quality and safety of surgical procedures. Robotics is not yet used in dentistry even though all the necessary technologies have already been developed and could easily be adapted. Some of the technologies are already used in dentistry, such as image-based simulation of implant surgery followed by the use of surgical guides, and creating digital impressions of pre parathions using an intra-oral scanner, after which a milling device produces the restoration, but we have not yet seen any robot able to prepare teeth for crowns, inlays or bridges. Such a robot would fundamentally be a dental drilling device coupled with a navigation device to determine the correct position of the device in relation to the patient. However this technique is very essential to have the minimal pain and reduce bleeding but control of these robots/joints are very complicated. This paper proposes new fuzzy type sliding mode controller for multi-DOF joints to control of motor vibration. The fuzzy (PD+I)2 single-input single-output (SISO) fuzzy system is used to control of chattering in sliding mode controller. In most research al researchers wants to eliminate the chattering but, this research focuses on chattering control. Various operation situations such as the set point control and the trajectory control are simulated. The simulation results demonstrate that the chattering and the steady state errors, which usually occur in the classical sliding mode control, are limitation control and satisfactory trajectory tracking is achieved.

목차

Abstract
 1. Introduction and Background
 2. Theorem:
 3. Methodology: Design Limit Chatter/Oscillation Control
 4. Results
 5. Conclusion
 Acknowledgment
 References

키워드

sliding mode controller Dental robot manipulator dental automation fuzzy logic controller vibration control multi degrees of freedom joint

저자

  • Maryam Rahmani [ ntelligent System and Robotic Lab, Iranian Institute of Advanced Science and Technology (IRAN SSP), Shiraz/Iran ]
  • Nasim Sobhani [ ntelligent System and Robotic Lab, Iranian Institute of Advanced Science and Technology (IRAN SSP), Shiraz/Iran ]
  • Hamid Cheraghi Farzin Piltan [ ntelligent System and Robotic Lab, Iranian Institute of Advanced Science and Technology (IRAN SSP), Shiraz/Iran ]
  • Farzin Matin [ ntelligent System and Robotic Lab, Iranian Institute of Advanced Science and Technology (IRAN SSP), Shiraz/Iran ]

참고문헌

자료제공 : 네이버학술정보

간행물 정보

발행기관

  • 발행기관명
    보안공학연구지원센터(IJHIT) [Science & Engineering Research Support Center, Republic of Korea(IJHIT)]
  • 설립연도
    2006
  • 분야
    공학>컴퓨터학
  • 소개
    1. 보안공학에 대한 각종 조사 및 연구 2. 보안공학에 대한 응용기술 연구 및 발표 3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최 4. 보안공학 기술의 상호 협조 및 정보교환 5. 보안공학에 관한 표준화 사업 및 규격의 제정 6. 보안공학에 관한 산학연 협동의 증진 7. 국제적 학술 교류 및 기술 협력 8. 보안공학에 관한 논문지 발간 9. 기타 본 회 목적 달성에 필요한 사업

간행물

  • 간행물명
    International Journal of Hybrid Information Technology
  • 간기
    격월간
  • pISSN
    1738-9968
  • 수록기간
    2008~2016
  • 십진분류
    KDC 505 DDC 605

이 권호 내 다른 논문 / International Journal of Hybrid Information Technology Vol.8 No.10

    피인용수 : 0(자료제공 : 네이버학술정보)

    함께 이용한 논문 이 논문을 다운로드한 분들이 이용한 다른 논문입니다.

      페이지 저장