Earticle

초록

영어

In today’s trend, the importance of Distributed Generation (DG) implementation in the distribution system (DS) becomes more significant with respect to proper location, sizing and reduction of losses. In this paper the location and size of DG were discussed based on Voltage Limitation Index (VLI). This index is used to ensure that all the buses in the network have acceptable voltage profile according to the distribution permissible limits. After determining the DG size and location a comprehensive analysis on cost of DG, energy loss occurred and savings obtained in the network were listed. The significance of VLI was tested on IEEE 33 and 69 bus DS under initial configuration state as well as in feeder reconfigured state also.

목차

Abstract
 1. Introduction
 2. Problem Formulation
 3. Results and Discussion
  3.1. 33-Bus Test System
  3.2. 69- Bus Test System:
 4. Conclusion
 References

키워드

저자

• S Vidyasagar [ Department of EEE, SRM University, Tamilnadu, India ]
• K Vijayakumar [ Department of EEE, SRM University, Tamilnadu, India ]
• R Ramanujam [ Department of EEE, SRM University, Tamilnadu, India ]
• D.Sattianadan [ Department of EEE, SRM University, Tamilnadu, India ]
• Noraj Kumar [ Department of EEE, SRM University, Tamilnadu, India ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Control and Automation

• 간기

  월간

• pISSN

  2005-4297

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605