Earticle

초록

영어

To nickel base superalloy in dry cutting, the milling experiment be done in the four-axis machining center with ceramic tool WG300 is in order to know the influence of cutting speed to chip morphology through the macroscopic observation on chip by optical microscope and the analysis of chip morphology. Then, focus on the machining features of GH3039, reasonable orthogonal test be designed, after which getting the influence of different level’s value to milling force and its change law based on the range analysis of experiment datum.

목차

Abstract
 1. Instructions
 2. Experiment Condition and Project
  2.1. Experimental Facilities and Tool
  2.2. Experimental Project
  2.3. Range Analysis of Experiment
 3. Conclusions
 Acknowledgements
 References

키워드

저자

• Jinghe Li [ School of Mechanical Engineering, Heilongjiang University of Science and Technology, NO.2468 Puyuan Road, Harbin, 150022,China ]
• Wang Xi [ School of Mechanical Engineering, Heilongjiang University of Science and Technology, NO.2468 Puyuan Road, Harbin, 150022,China ]
• Min Qi [ Liaoning university of engineering and technology, Mechanical Engineering institute， Fuxin city Liaoning province 123000,China ]
• Yubo Liu [ School of Mechanical Engineering, Heilongjiang University of Science and Technology, NO.2468 Puyuan Road, Harbin, 150022,China ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of u- and e- Service, Science and Technology

• 간기

  격월간

• pISSN

  2005-4246

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605