R.Sridhar, K. C. Jayasankar, D. V. S. Aditya, G. Vinod Kumar
언어
영어(ENG)
URL
https://www.earticle.net/Article/A246004
※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.
원문정보
초록
영어
This paper emphasizes on proposing a cost effective photovoltaic (PV) fed 3 phase Induction motor drive which serves for rural pumping applications. Generally in a standalone system, the solar panels generate direct current energy which is then stored in rechargeable batteries and the battery set up in turn will serve as a source for the inverter. But here in this proposed work a new single stage battery-less power conversion is employed by designing a maximum power point tracker (MPPT) embedded boost converter which revolutionizes the present tradition and makes the overall cost of the setup to go down considerably. The proposed work is realized as a prototype consisting PV array of 500watts, MPPT aided boost converter, three phase inverter and a three phase squirrel cage induction drive of 357 watts. An efficient and low cost micro controller dspic4011 is used as the platforms to code and implement the prominent perturb and observe MPPT technique. Sinusoidal pulse width modulation (SPWM) is the control technique employed for the three phase inverter. To validate the experimental results simulation of the whole set up is carried out in Matlab/Simulink environment. Simulation and hardware results reveal that the system is versatile.
목차
Abstract 1. Introduction 2. Proposed System 2.1. PV Modeling and Characteristics 2.2. Perturb and Observe MPPT Technique 2.3. Boost Converter 2.4. Voltage Source Inverter 2.5. Induction Motor Drive 3. Results and Discussion 3.1. Simulation Results 3.2. Hardware Results 4. Conclusion References
키워드
Photo Voltaic (PV)Maximum power point tracking (MPPT)Perturb and Observe (P&O)Sinusoidal pulse width modulation (SPWM)Micro controllerSquirrel Cage Induction Motor (SCIM)
저자
R.Sridhar [ Dept of EEE, S. R. M. University, Chennai, India, ]
K. C. Jayasankar [ Dept of EEE, Prathyusha Institute of Technology and Management, Tamilnadu, India ]
D. V. S. Aditya [ Dept of EEE, S. R. M. University, Chennai, India ]
G. Vinod Kumar [ Dept of EEE, S. R. M. University, Chennai, India ]
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.8 No.5