This paper introduces a design and realization method of battery management system about emergency light based on time division multiplexing and balanced charging technology. Through Calculating state of electric charge by detecting the battery charge and discharge current and monitoring of a single voltage, the system achieves a balanced charge control methods and strategies, avoided battery overcharge and over-discharge, and further improves the efficiency of the battery, extending the battery life.
목차
Abstract 1. Introduction 2. Hardware Design 2.1. Hardware Overall Design 2.2 Microprocessor 2.3 SMBus I / O bus 2.4 Current Measurement 2.5 Single Voltage Measuring and Balance Control 2.6 Detection and Control Methods Device of Powered 2.7 IR Remote Control 2.8 Charge Management 2.9 Discharge Management 3. System Software Design 3.1 Acquisition and Single Voltage Balancing 3.2 Single Battery Control Methods of Charge Balance 4. Implemented Measuring System Compositon 4.1 Signal Detection 4.2 Control Signal 4.3 Power Supply 4.4 Ventilation Cooling 4.5 Charging Control 5. Conclusion References
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.8 No.5