Earticle

초록

영어

There are 10 sets of CNC equipment in a numerical controlled workshop, and set up the CAD/CAPP/CAM center, there is a problem that each production unit is an information island, which can not implement informatization management. This paper takes ZNE-100TL module realized the embedded Ethernet and RS-232C data transfer function as the hardware platform, takes VC++ as software platform, applied Ethernet technology to realize communication the CNC equipment with CAD/CAPP/CAM center. This is good for production management and data transmission in numerical controlled workshop, which can improve the production efficiency.

목차

Abstract
 1. Introduction
 2. Hardware Design
  2.1. Overall Design
  2.2. Ethernet and RS-232C Data Conversion Module
 3. Software Design
  3.1. Operation Interface Design
  3.2. Program Flow
 4. Communications Function
  4.1. Alarm Function
  4.2. Data Transmission Function
 5. Experimental Verification
 6. Conclusion
 Acknowledgements
 References

키워드

저자

• Wang Qingcheng [ School of Mechanical Engineering, Jilin Teachers’ Institute of Engineering and Technology, Changchun 130052, China ]
• Cao Guohua [ School of Mechanical and Electric Engineering, Changchun University of Science and Technology, Changchun 130022, China ]
• Mao Ning [ China North Vehicle Research Institute, Beijing 100072, China ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Future Generation Communication and Networking

• 간기

  격월간

• pISSN

  2233-7857

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605