Earticle

초록

영어

This paper presents the dynamic model and control strategy of active power filter (APF) on dq0-frame in three-phase four-wire system. The structure of the APF is the three-leg split-capacitor. The dq0-frame with Fourier (DQF) method is used to calculate the reference currents on dq0-frame. The pulse width modulation (PWM) with PI controllers is considered in the paper. Moreover, the principle of the PI controller design for three current loops and two voltage loops are completely presented. The discrete design approach is used to design all controllers in the system. In addition, the hardware in the loop (HIL) technique is applied to simulate the harmonic elimination using the APF in the paper. The results show that the control strategy and the design approach presented in the paper can provide the good performance of the APF. Furthermore, the source currents after compensation can also follow the IEEE Std.519-1992 and IEEE Std.1459-2010.

목차

Abstract
 1. Introduction
 2. Review of dq0-frame with Fourier (DQF) Algorithm
 3. Review of Mathematical Model for Three-Phase Four-Wire Active Power Filter
 4. Controls of Active Power Filter
  4.1. Design of Current Loop Control
  4.2. Design of Voltage Loop Control
 5. Hardware in the Loop Simulation
 6. Simulation Results and Discussion
 7. Conclusion
 Acknowledgements
 References

키워드

저자

• Phonsit Santiprapan [ School of Electrical Engineering Suranaree University of Technology, SUT Nakhon Ratchasima, THAILAND ]
• Kongpol Areerak [ School of Electrical Engineering Suranaree University of Technology, SUT Nakhon Ratchasima, THAILAND ]
• Kongpan Areerak [ School of Electrical Engineering Suranaree University of Technology, SUT Nakhon Ratchasima, THAILAND ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Control and Automation

• 간기

  월간

• pISSN

  2005-4297

• 수록기간

  2008~2016

• 십진분류

  KDC 505 DDC 605