This paper describes the case of Independent Software Verification and Validation(V&V). As an example, verification and validation of the graphic recorder is introduced. Graphic recorder as a verification and validation paradigm describe the qualification approaching techniques and methods. Graphic recorder is a measurement data recording device with 5.5 inch TFT liquid crystal display instead of a paper. It mainly describes V&V criteria, testing approach, software verification methodology, techniques and procedures. However, hardware based equipment qualification (i.e. environment qualification, seismic qualification, and EMI/RFI qualification) has been excluded. The V&V methods for each phase of the software life cycle and V&V input-output tasks, with a focus on the processes are described. From the initial phase to the final phase of development, development and testing/verification were performed according to the software life cycle based on information engineering methodology. The suggested validation and verification paradigm is satisfied with SRP7/BTP-14 criteria, which is the digital software licensing standard for safety-critical system (for example, aerospace, railways, automobile and nuclear industry etc). The paper addresses the pass/fail criteria for each phase of the software life cycle referenced by hierarchical international standard framework.
목차
Abstract 1. Introduction 2. Requirement based System Testing 2.1. Applicable Code & Standards 2.2. Testing Environment 3. Testing of the Major Safety Parameter Cases 4. System Tests 5. Conclusions Acknowledgements References
Jangyeol Kim [ Instrumentation & Control and Human Factors Division/Korea Atomic Energy Research Institute(KAERI) 989-111 Daedeok-daero, Yuseong-gu, Daejeon, Republic of Korea 305-353 ]
Soongohn Kim [ Department of Computer and Game Science, Joongbu University, 101 Daehakro, Chubu-Meon, GumsanGun, Chungnam, 312-702, Korea ]
Corresponding Author
보안공학연구지원센터(IJSEIA) [Science & Engineering Research Support Center, Republic of Korea(IJSEIA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Software Engineering and Its Applications
간기
월간
pISSN
1738-9984
수록기간
2008~2016
등재여부
SCOPUS
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Software Engineering and Its Applications Vol.8 No.3