Yeongseok Lee, Hong-geun Kim, Olly Roy Chowdhury, Changsun Shin, Yongyun Cho, Jangwoo Park
언어
영어(ENG)
URL
https://www.earticle.net/Article/A218434
※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.
원문정보
초록
영어
This paper is to realize an electric power generator utilizing wave force through hydraulic mechanism. The wave power generator using hydraulic mechanism is very useful since it produces energy in the ocean. This experiment used a check valve, oil pressure tube, and generator to embody the wave power generator through hydraulic mechanism. Check valve was used to make the fluid flow in one direction, and oil pressure tube for the movement of the fluid. The volume and pressure of the fluid in the structure were calculated. The factors which affected the volume and pressure of the fluid in the structure were analyzed. And the results from this study shall be applied to the actual marine construction, and utilized in the research for the reinforcement of the structure.
목차
Abstract 1. Introduction 2. Hydraulic Mechanism 3. Development of Small Generator Using Hydraulic Mechanism 3.1. Small generator structures using a hydraulic mechanism 3.2. Prototype analysis 4. Experimental Procedures and Results 5. Application plan 6. Conclusion Acknowledgements References
Yeongseok Lee [ Dept. Information and Communication Engineering, Sunchon National University, 255 Jungangno, Suncheon, Jeonnam 540-950, Republic of Korea ]
Hong-geun Kim [ Dept. Information and Communication Engineering, Sunchon National University, 255 Jungangno, Suncheon, Jeonnam 540-950, Republic of Korea ]
Olly Roy Chowdhury [ Dept. Information and Communication Engineering, Sunchon National University, 255 Jungangno, Suncheon, Jeonnam 540-950, Republic of Korea ]
Changsun Shin [ Dept. Information and Communication Engineering, Sunchon National University, 255 Jungangno, Suncheon, Jeonnam 540-950, Republic of Korea ]
Yongyun Cho [ Dept. Information and Communication Engineering, Sunchon National University, 255 Jungangno, Suncheon, Jeonnam 540-950, Republic of Korea ]
Jangwoo Park [ Dept. Information and Communication Engineering, Sunchon National University, 255 Jungangno, Suncheon, Jeonnam 540-950, Republic of Korea ]
Corresponding Author
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.7 No.3