Earticle

초록

영어

In this study, it is proposed to use software to create MDDI protocol packet which is required for the display device. The previously proposed method to create MDDI protocol packet was implemented in FPGA. In the previous MDDI interface design method, data and synchronization signal were created inside of the FPGA chip. FPGA chip creates data received from CPU into serial data and creates packets and then controls signals. This design method is intended to reduce CPU load. In this paper, the method of creating data in software, which was notpresent in the previous FPGA is proposed for design of data transmitter using the MDDI interface method.

목차

Abstract
 1. Introduction
 2. Hardware and Software Designs
  2.1. Hardware design
  2.2. Software design
 3. Measurement Result and Consideration
  3.1 Sub-frame header packet
  3.2 Video stream packet
  3.3 Link shutdown packet
  3.4 Register access packet
  3.5 Link hibernation
 5. Conclusion
 References

키워드

저자

• Jong-Moon Kim [ PaiChai University, Doma2-Dong, SeoGu, DaeJeon, Korea ]
• Chang-Su Kim [ PaiChai University, Doma2-Dong, SeoGu, DaeJeon, Korea ]
• Hoe-Kyung Jung [ PaiChai University, Doma2-Dong, SeoGu, DaeJeon, Korea ] Corresponding Author

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Multimedia and Ubiquitous Engineering

• 간기

  월간

• pISSN

  1975-0080

• 수록기간

  2008~2016

• 등재여부

  SCOPUS

• 십진분류

  KDC 505 DDC 605