Earticle

초록

영어

Early gates were based on an electronic switch that was only turned on or off according to the input signal level. Variety digital noise reductions are in both hardware and software form and these are far more detailed than gates or expanders and generally work by first separating the incoming signal into a large number of split frequency bands. Noise has been usually added to an electrical signal there is no perfect way to remove it, although there are digital process that are effective at significantly reducing the level of random noise. However, it can be good practice to assume that any noise engineer collect along the way is going to be a permanent part of the recording and that all possible ways should be taken to minimize it. This means that engineer should always optimize gain structure, un-route unused mix channels and take all other practical measures to reduce noise at the source. Even though engineers try to do the best efforts, some noise can be remaining in signal. It is physical matter but the best way is to less unwanted noise.

목차

Abstract
 1. Introduction
 2. Noise Reduction
  2.1. Noise reduction outdoors
  2.2 Masking noise
  2.3. Attack and release
  2.4. Range and Hold time
  2.5. Hysteresis and Side chains
  2.6. Digital Noise Reduction
 3. Conclusion
 References

키워드

저자

• Yoemun Yun [ Dept. of Applied Music, Chungwoon University Daehakgil-25, Hongseong, Chungnam, South Korea ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  International Journal of Multimedia and Ubiquitous Engineering

• 간기

  월간

• pISSN

  1975-0080

• 수록기간

  2008~2016

• 등재여부

  SCOPUS

• 십진분류

  KDC 505 DDC 605