This paper discusses the performance curves analysis based on stochastic network calculus under the diversified requirements from different applications in network. Such requirements need different quality of service (QoS), one of which is performance curve analysis. This paper proposes a theory model to investigate the performance curves in SNC. This model integrates the probability calculation into performance analysis model so as to present and analyze the statistical reuse characteristic of data stream over the Internet. The QoS model combines the above two analysis curves without using the min-plus algebra in order to avoid the noncooperation caused by Prb-MinPlus. Several innovations are included in this model. Firstly, the arrival curve indicates the stochastic data steam in the network by integrating the probability functions. Thus, the data stream is able to reflect the current situation in a network. Secondly, the model proposed in this paper integrates arrival curve and service curve to build up the model. As a result, the performance analysis could be carried out more precise. Thirdly, the proposed model has been compared with Jiang-SNC in terms of probability upper boundary and overall performance. It is observed that, the proposed model outperforms Jiang-SNC in QoS and can avoid the problem of Prb-MinPlus.
목차
Abstract 1. Introduction 2. Performance Analysis Model in SNC 2.1. Arrival curve and service curve. 2.2. Performance analysis using curves. 2.3 QoS analysis 3. Experiments and Discussions 4. Conclusion Acknowledgements References
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.7 No.2