The dynamic pressures at a distance of 500mm away from the spout for the aircraft tire burst jets were measured in the aircraft main landing gear. The dynamic pressures were treated for equivalent static pressures while the distributions of the equivalent static pressures were simulated by linear and cubic spline interpolation functions based on MATLAB software. The results showed that the equivalent static pressure close to the middle region of the sector is relatively large at the same distance from the spout. The distributions by linear interpolation are more uniform than cubic spline interpolation, but the results from the cubic spline interpolation are more rounded than the other. The equivalent static pressure less 500mm away from the spout was obtained by the interpolations. Moreover, the equivalent static pressures are usually higher by cubic spline interpolation than linear interpolation.
목차
Abstract 1. Introduction 2. Pressure Measurement of the Aircraft Tire Burst Jets 2.1 Setting aircraft tire burst test 2.2 The tire burst jets pressures distribution in tests 2.3 Equivalent static pressures distributions in tests 3. The Numerical Simulation of Equivalent Static Pressures Distribution 3.1 Interpolation method introduction 3.2 The equivalent static data interpolation based on MATLAB 3.3 Distributions of the equivalent static pressures in tests 3.4 Interpolation results of equivalent static pressure at the key parts 4. Conclusions References
Runlian Jiang [ College of Field Engineering, PLA Univ. of Sci. &Tech Hai Fu Xiang Street 1, Nanjing, Jiangsu, 210007, Chin, Zhenjiang Watercraft College of PLA, Zhenjiang, Jiangsu, 212003 China ]
Yaohua Wang [ College of Field Engineering, PLA Univ. of Sci. &Tech Hai Fu Xiang Street 1, Nanjing, Jiangsu, 210007, China ]
Chengfei Fan [ College of Field Engineering, PLA Univ. of Sci. &Tech Hai Fu Xiang Street 1, Nanjing, Jiangsu, 210007, China ]
Mianjun Duan [ College of Field Engineering, PLA Univ. of Sci. &Tech Hai Fu Xiang Street 1, Nanjing, Jiangsu, 210007, China ]
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.7 No.1