For the issue of being difficult to carry out various experiments of vehicle braking systems, a real-time simulation platform which is an vehicle braking pressure based on xPC Target is proposed. In the design of platform, the method is studied through writing CS-function driver development. Under MATLAB RTW, the problems of hardware simulation in the loop to support I / O device is resolved in xPC Target toolbox. Upon the analysis of the basic principles and structure of the driver, the solution to the key issues such as register operation and base seeking address are studied. And PCI-1710 driver is developed. The verifications about the driver validation of the data acquisition card and closed-loop regulation to the vehicle braking pressure are completed with the platform. The experimental results show that the A / D sampling frequency of acquisition card can be up to 10 kHz, signals can be displayed in real time and the test platform can be long-running. The development process is stable. Pressure waveforms consistent with the waveforms measured by the oscilloscope. The braking pressure can be adjusted by the real-time simulation platform. A new experimental method is provided for research on the vehicle braking performance.
목차
Abstract 1. Introduction 2. xPC Target Real-time Simulation Experiment Platform 3. PCI-1710 Driver Development 3.1. S function structure 3.2. Basic points of writing driver 3.3. Module package and storage 4. Experiment and Results Analysis 5. Conclusions Acknowledgements References
키워드
xPC Targetreal-time simulationdriverbraking system
저자
Shan Yi [ Electrical & Electronic Teaching and Training Center ]
Li Wenjuan [ School of Electrical and Electronic Engineering Harbin University of Science &Technology, Harbin, China ]
Wei Jingwei [ School of Electrical and Electronic Engineering Harbin University of Science &Technology, Harbin, China ]
보안공학연구지원센터(IJCA) [Science & Engineering Research Support Center, Republic of Korea(IJCA)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Control and Automation
간기
월간
pISSN
2005-4297
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Control and Automation Vol.7 No.1