Earticle

초록

영어

The studies of superconducting fault current limiter (SFCL) for reduction of the fault current are actively underway in the worldwide. In this paper, we analyzed the characteristics of a new type SFCL using the conventional transformer and superconducting elements combined mutually. The secondary and third windings of this SFCL were connected the load and the superconducting element, respectively. The electric power was provided to load connected to secondary windings of the transformer in normal state of power system. On the other hand, when the fault occurred in power system, the fault current was limited by closing the line of third winding of the transformer. At this time, the ripple phenomenon of the fault was minimized by opening the fault line in secondary winding of a transformer in power system. The sensing of the fault state was performed by the CT(current transformer) and then turn-on and turn-off switching behavior of the SFCL was performed by the SCR(silicon-controlled rectifier). As a result, the proposed SFCL limited the fault current within a half-cycle efficiently. We confirmed that the fault current limitation rate was changed according to the winding ratio of a transformer.

목차

Abstract
 1. INTRODUCTION
 2. EXPERIMENTAL METHODS AND CONFIGURATION
 3. RESULTS AND DISCUSSION
  3.1. Each Phase Current Curves and SCR switching operation
  3.2. Voltage Curves of a Superconducting Element
 4. CONCLUSION
 ACKNOWLEDGMENT
 REFERENCES

키워드

저자

• B. I. Jung [ Chosun University, Gwangju, Korea ] Corresponding author
• H. S. Choi [ Chosun University, Gwangju, Korea ]

참고문헌

발행기관

간행물

표지보기 관심저널 등록

• 간행물명

  한국초전도·저온논문지 (구 한국초전도저온공학회논문지) [Progress in Superconductivity and Cryogenics]

• 간기

  계간

• pISSN

  1229-3008

• eISSN

  2287-6251

• 수록기간

  1999~2026

• 등재여부

  KCI 등재,SCOPUS

• 십진분류

  KDC 427 DDC 537