S.-m. Hwang, K. K. Yu, Y. H. Lee, C. S. Kang, K. Kim, S. J. Lee
언어
영어(ENG)
URL
https://www.earticle.net/Article/A212545
※ 기관로그인 시 무료 이용이 가능합니다.
※ 학술발표대회집, 워크숍 자료집 중 4페이지 이내 논문은 '요약'만 제공되는 경우가 있으니, 구매 전에 간행물명, 페이지 수 확인 부탁 드립니다.
4,000원
원문정보
초록
영어
For sensitive measurements of micro-Tesla nuclear magnetic resonance (μT-NMR) signal, a low-noise superconducting quantum interference device (SQUID) system is needed. We have fabricated a liquid He dewar for an SQUID having a large diameter for the pickup coil. The initial test of the SQUID system showed much higher low-frequency magnetic noise caused by the thermal magnetic noise of the aluminum plates used for the vapor-cooled thermal shield material. The frequency dependence of the noise spectrum showed that the noise increases with the decrease of frequency. This behavior could be explained from a two-layer model; one generating the thermal noise and the other one shielding the thermal noise by eddy-current shielding. And the eddy-current shielding effect is strongly dependent on the frequency through the skin-depth. To minimize the loop size for the fluctuating thermal noise current, we changed the thermal shield material into insulated thin Cu mesh. The magnetic noise of the SQUID system became flat down to 0.1 Hz with a white noise of 0.3 fT/√Hz, including the other noise contributions such as SQUID electronics and magnetically shielded room, etc, which is acceptable for low-noise μT-NMR experiments.
목차
Abstract 1. INTRODUCTION 2. STRUCTURE OF DEWAR 2.1. Design of the Dewar 2.2. Measurement and Analysis of Thermal Noise 2.3. Attenuation of Noises by Inner Tube 3. CONCLUSIONS REFERENCES ACKNOWLEDGMENT
키워드
SQUIDdewarmicro-Tesla NMRmagnetic noisethermal shieldeddy current shielding
저자
S.-m. Hwang [ Korea Research Institute of Standards and Science, Daejeon, Korea ]
K. K. Yu [ Korea Research Institute of Standards and Science, Daejeon, Korea ]
Y. H. Lee [ Korea Research Institute of Standards and Science, Daejeon, Korea ]
Corresponding author
C. S. Kang [ Korea Research Institute of Standards and Science, Daejeon, Korea ]
K. Kim [ Korea Research Institute of Standards and Science, Daejeon, Korea ]
S. J. Lee [ Korea Research Institute of Standards and Science, Daejeon, Korea ]