Chee-Hoe Pang, Jer-Vui Lee, Yea-Dat Chuah, Yong-Chai Tan, N. Debnach
언어
영어(ENG)
URL
https://www.earticle.net/Article/A204675
※ 원문제공기관과의 협약기간이 종료되어 열람이 제한될 수 있습니다.
원문정보
초록
영어
Single phase induction motors are the most widely used motors for home appliances. The AC induction motor has a simple rugged design. Other advantages include low cost, low maintenance and can be connected directly to an AC power source. When power is supplied to an induction motor at the recommended specifications, it runs at its rated speed [1]. However, many applications need variable speed operation. One of them is a fan. This paper presents a design of a microcontroller based motor controller with heat sensor which is used to vary the speed of a motor in a smart home. The discussion includes the design of a controller that varies the speeds of the motor with respect to the ambient temperature in a smart home environment. The controller is embedded as an addition to a stand fan. A phase control method is selected to be implemented in this design. The power delivery to the motor is controlled by the firing angle of a Triac where it controls the AC power supply. With the firing time controlled by the Triac, the input power to the motor can be controlled accordingly. In addition, a hand-clap circuit is also introduced which acts as a switch to activate or deactivate the motor.
목차
Abstract 1. Introduction 2. System Architecture 3. Hand Clap Switch 4. PIC Microcontroller Circuit 4.1. Analog to Digital Conversion (ADC) 5. Phase Control Method of a PSC Induction Motor 5.1. Phase Control Circuit 6. Results and Discussions 6.1. Volumetric Flow Rate Test 6.2. Thermal Flow Simulation 6.3. Hand Clap Response Test 6.4. Overall Performance Test 7. Conclusion and Future Work References
키워드
Single phase induction motorphase controltriacmicrocontroller
저자
Chee-Hoe Pang [ Faculty of Engineering and Science, Universiti Tunku Abdul Rahman, Kuala Lumpur, Malaysia. ]
Jer-Vui Lee [ Faculty of Engineering and Science, Universiti Tunku Abdul Rahman, Kuala Lumpur, Malaysia. ]
Yea-Dat Chuah [ Faculty of Engineering and Science, Universiti Tunku Abdul Rahman, Kuala Lumpur, Malaysia. ]
Yong-Chai Tan [ Faculty of Engineering and Science, Universiti Tunku Abdul Rahman, Kuala Lumpur, Malaysia. ]
N. Debnach [ Faculty of Engineering and Science, Universiti Tunku Abdul Rahman, Kuala Lumpur, Malaysia. ]
보안공학연구지원센터(IJSH) [Science & Engineering Research Support Center, Republic of Korea(IJSH)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Smart Home
간기
격월간
pISSN
1975-4094
수록기간
2008~2016
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Smart Home Vol.7 No.4