This paper proposes LED driver to minimize power consumption due to LED forward voltage difference and temperature rising. Compared to conventional LED driver, the proposed driver had excellent stability, brief structure and linear output voltage of DC-DC boost converter. With the channel current set at 100mA, the on/off switchover was controlled by means of the PWM control signal in the simulation and actual installation. As a result, it turned out that the normal LED current value of 100mA was produced according to the input PWM control signal.
목차
Abstract 1. Introduction 2. The Structure and Operation Principle of BLU Driver 3. The Design and Simulation of BLU Driver Block 3-1. Design of Bias Blocks 3-2. PAM Control Block Design 4. Conclusion Acknowledgements References
키워드
LEDBLUControl FunctionDriver.
저자
Seung-Woo Lee [ Research & Development Center LDT Co. Ltd Cheonan, Korea ]
Sun-Yeob Kim [ Department of Information and Communication Engineering, Namseoul University Cheonan, Korea ]
보안공학연구지원센터(IJMUE) [Science & Engineering Research Support Center, Republic of Korea(IJMUE)]
설립연도
2006
분야
공학>컴퓨터학
소개
1. 보안공학에 대한 각종 조사 및 연구
2. 보안공학에 대한 응용기술 연구 및 발표
3. 보안공학에 관한 각종 학술 발표회 및 전시회 개최
4. 보안공학 기술의 상호 협조 및 정보교환
5. 보안공학에 관한 표준화 사업 및 규격의 제정
6. 보안공학에 관한 산학연 협동의 증진
7. 국제적 학술 교류 및 기술 협력
8. 보안공학에 관한 논문지 발간
9. 기타 본 회 목적 달성에 필요한 사업
간행물
간행물명
International Journal of Multimedia and Ubiquitous Engineering
간기
월간
pISSN
1975-0080
수록기간
2008~2016
등재여부
SCOPUS
십진분류
KDC 505DDC 605
이 권호 내 다른 논문 / International Journal of Multimedia and Ubiquitous Engineering Vol.7 No2