※ 기관로그인 시 무료 이용이 가능합니다.
※ 학술발표대회집, 워크숍 자료집 중 4페이지 이내 논문은 '요약'만 제공되는 경우가 있으니, 구매 전에 간행물명, 페이지 수 확인 부탁 드립니다.
4,000원
원문정보
초록
영어
This paper presents an experimental and numerical study on current limiting characteristics of a fault current controller (FCC). The FCC consists of an AC/DC power converter, a superconducting coil, and a control unit. Even though some previous researches proved that the FCC could adjust the fault current level, the current limiting characteristics by the superconducting coil should be investigated for design of the coil. In this paper, four kinds of model coils were tested; 1) air core, 2) iron core without any bias, 3) reversely magnetized core (RMC) using permanent magnets, and 4) RMC using an electromagnet. Based on a comparative study, it is confirmed that a RMC by an electromagnet (EM) could increase the effective inductance of the coil. In this paper, a numerical code to simulate the HTS coil with RMC was developed. This code can be applied to design the HTS coil with active reversely magnetized bias coil.
목차
Abstract 1. INTRODUCTION 2. REVERSELY MAGNETIZED CORE 2.1. Current Limiting Characteristics of FCC 2.2. Effectiveness of RMC 3. EXPERIM ENTAL ANALYSIS 3.1. Experimental Setup 3.2. Test result 1: Air-core and iron-core w/o bias 3.3. Test result 2: RMC using PMs 3.4. Test result 3: RMC using an EM 4. NUMERICALANALYSIS 4.1. Simulation model 4.2. Simulation result 5. CONCLUSIOIN ACKNOWLEDGMENT REFERENCES
키워드
Current limiting characteristicsfault current controllerreversely magnetized coresuperconducting coil
저자
Min Cheol Ahn [ Department ofElectrical Engineering, Kunsan National University ]
Corresponding author
Tae Kuk Ko [ School of Electrical and Electronic Engineering, Yonsei University ]